Installation Requirements; Tools And Parts - Maytag MEDB700BW0 Installation Instructions Manual

INSTALLATION REQUIREMENTS
TOOLS AND PARTS
Gather the required tools and parts before starting installation.
Read and follow the instructions provided with any tools listed
here.
Tools needed:
Flat-blade screwdriver
#2 Phillips screwdriver
[® ®]
Adjustable wrench that
opens to 1" (25 mm) or
hex-head socket wrench
Level
Wire stripper (direct wire
installations)
db
Vent clamps
Parts supplied (all models):
Leveling legs (4) for models
with riser
Leveling legs (4) for models
without riser
Parts supplied (steam models):
"Y" connector
5' (1.52 m) inlet hose
Short inlet hose
Rubber washer
Caulking gun and
compound (for installing
new exhaust vent)
Tin snips (new vent
installations)
Parts package is located in dryer drum. Check that all parts
are included.
Parts needed: (Not supplied with dryer)
Check local codes. Check existing electrical supply and venting.
See "Electrical Requirements" and "Venting Requirements"
before purchasing parts.
Mobile home installations require metal exhuast system hardware
available for purchase from the dealer from whom you purchased
your dryer. For further information, please refer to the "Assistance
or Service" section in your "Use and Care Guide."
Optional Equipment: (Not supplied with dryer)
Refer to your "Use and Care Guide" for information about
accessories available for your dryer.
1/4" nut driver
(recommended)
Tape measure
Pliers