HP IDB5220N User Manual page 62

NOTE:
• For disposal or recycling information, contact your local authorities or the Electronic Industries Alliance at
www.eiae.org.
• You can find safety information about the lamp at
www.hp.com/hpinfo/globalcitizenship/environment/productdata.
• Consult the installation instructions packed with the replacement lamp module for any updates to the
following.
1. Turn off the television and allow it to cool for at least 30 minutes.
2. After the 30 minutes (or more) has elapsed, unplug the power cord to remove AC power from the television.
3. On the back of the television, unscrew the single
slotted screw located at the top center edge of the
lamp access cover, then lift and remove the cover.
4. Loosen the screw (1) on the lamp module (the screw
does not come completely out), then pull out the
module using its handle (2).
5. Insert the new lamp module into the opening, firmly
press it into place, and tighten the screw (1) loosened
in step 4.
6. Insert the tabs on the lower edge of the lamp cover
into the openings in the case. Position the cover and
replace the screw removed in step 3.
7. Plug in the power cord and turn on the television. If the lamp does not turn on after the warm-up period,
reinstall the lamp module by repeating the steps above.
42
Fixing Problems