Advertisement
Available languages
Available languages
Move dishwasher
into cabinet opening
1. Grasp the sides of the dishwasher
at the edges of the door panel.
2. Tilt dishwasher
backwards
on
wheels and move dishwasher
close
to cabinet opening.
Do not push on
the front of the panel or on the
console--they
may dent.
3. If dishwasher
has a power supply
cord, insert power supply cord into hole cut into
cabinet.
If using direct wire, check that it is on the right front
side of opening.
4. Check that water line is on the left side of opening
and
drain hose is near the center of the hole in the cabinet.
5. Slowly move dishwasher
completely
into cabinet
opening.
Do not kink or pinch copper tubing,
drain
hose, power supply cord or direct wire between
dishwasher
and cabinet.
HelpfulTip:
Once the dishwasher
is in position,
you
may have to support the front of the dishwasher
by
raising, lowering
or shimming
front feet.
6. Remove cardboard
from under dishwasher.
NOTE:
It is all right
if dishwasher
fits tightly
into cabinet
opening.
Do not remove
insulation
blanket
--the
blanket
reduces
the sound
level.
Level the dishvvasher
Align front of dishwasher
door panel with cabinet
doors.You
may need to adjust alignment
to be even
with your cabinets.
HelpfulTip:
Prop up one side of frame to hold
dishwasher
up off floor when adjusting
front legs.
2. Check that leveling
legs are firmly
against the floor.
3. Close and latch the door, and place level against the
front panel. Check that dishwasher
is plumb.
If needed,
adjust leveling
leg or add shims under rear wheel until
dishwasher
is plumb.
/
t
4. Repeat for other side of dishwasher.
NOTE: Shims must be securely attached to floor to prevent
their movement
when the dishwasher
is operated.
5. Place level against top front
opening
of tub. Check that
dishwasher
is level from side to
side. If dishwasher
is not level,
adjust front legs up or down until
dishwasher
is level.
Make
Electrical
Connection
Check "Electrical
requirements"
section.
You need to:
, have the correct
electrical
supply
and recommended
grounding
method.
If you are:
, direct wiring,
use Option
1
, using a power supply cord, use Option
2
Option
1: Direct wire method
1. Route direct wire so that it does not touch dishwasher
motor
or lower part of dishwasher
tub.
2. Pull direct wire through
hole in terminal
box.
Helpful Tip:
, Select the proper size twist-on
connectors
to connect your household
__
wiring
to 16-gauge dishwasher
wiring.
, Insert wire ends into twist-on
connector.
Do not pre-twist
bare wire.
,Twist
connector.
, Gently tug on wires to be sure both
are secured.
3. Connect the wires as follows
using twist-on
connectors
sized to connect direct wire to 16-gauge dishwasher
wire:
Powersupplywire:
Terminalboxwire:
white-.,_-_.-white
black_-_.-black
groundwire_--_ground connector
13
Advertisement
