Advertisement
Available languages
Available languages
Install
the door handle
(on some models)
IMPORTANT:
Do not scratch
the front
panel
during
this
procedure.
1.
Remove
the door
handle
and hardware
bag containing
the setscrews
and Allen
wrench
from
the cardboard
box.
2. Start set screws in handle.
3.
Place
handle
on mounting
studs
with
the set screws
facing
down.
4.
Push the door
handle
tightly
against
the door.
Insert
the
short
end of the Allen
wrench
into the setscrews.
Tighten
the setscrews
1/4 turn
past snug.
Retain
Allen
wrench
with
Installation
Instructions.
handle
setscrew
(in bottom
of handle)
.._)
wrench
Pro Line ® Series
1. Remove the Pro Lind" Series handle and two screws
from handle package.
2. Make sure plastic spacers are still attached to the door.
3. Attach the handle to the factory-supplied
full front panel
as shown.
plastic spacers
Install
door panel
(Pro Line' _ > s eries)
NOTE: Features on your
dishwasher
may differ
from model shown.
For top vented
models
with
a factory-supplied
top vent
stainless
or painted
full
front
panel:
1. Remove
the carton
containing
the factory-supplied
full
front
panel.
2. Remove
the handle
package
from
the front
of the
shipping
base.
3. Remove
the inner
panel
from
the door.
4. With
aTORX"
screwdriver,
remove
three
screws
from
both
sides
of the door.
Hold
the inner
panel
up while
removing
the screws.
5. Gently
set panel
aside.
NOTE:
Some
models
have
4 screws
per side.
screws
screws
door
panel
do not remove screw.
6. Lay the factory-supplied
full
front
panel
face down
on a
protective
non-scratching
surface.
7. Place the inner
panel
on the back of the full front
panel
as shown
and attach,
using
the four #10-16
x 3/8" screws
in the literature
package.
4 screws
full front panel
inner door panel
top of panel
8. Attach
the factory-supplied
full front
panel,
inner
panel,
and handle
assembly
to the door.
9. Reinstall
the two
uppermost
screws
into the inner
panel,
do not tighten
completely.This
will
hold
the full
front
panel
in place
on the door
frame.
2 screws ,
10. Install
the two #8-18
x 1-3/8"
screws
from
the literature
package
in the top corners
of the door.
11. Align
the top edge
of the full front
panel
with
the top
edge
of the console
and secure
corner
screws.
12. Tighten
the two
screws
installed
in Step
9.
13. Reinstall
and tighten
the remaining
screws
in the inner
panel.
s
2 screws
align top edges
11
Advertisement
