Connect To Water Supply; Install Drawer Front Panel - KitchenAid KUDD01SSSS0 Installation Instructions Manual

Option 3: Air break connection
1. Route the drain hose as shown.
2. Decide if the drain hose needs to be trimmed. If it does,
trim it.
3. Slip a wire clip over the drain
hose. Push the hose into the
drain hose connector firmly, 5
clicks.
4. Position the wire clip between
the two positioning ribs on the
drain hose connector.
_'b wire clip
drain hose connector
5. Attach the drain hose connector to the air break using the
supplied hose clamp.
_/air break
//_ d'rain hose I
//L_/connector J
Z_Z
oooo_m_m_
valve
/ _. water supply
-- 8" (20,3 cm) rain. bend
radius from valve
Option 1 : install standard front panel
(on some models)
1. Remove front panel from box and discard all shipping
material.
2. Remove the tape securing the connector and wires from the
panel and the metal plate. Discard tape.
3. Connect the end of the medallion connector to the connector
from the drawe£
wire
opening
front panel
connector
4. Gently feed the wires and connectors into the metal plate wire
opening.
5. Line up front panel tabs to slots in metal plate. Do not pull the
connector from the wire opening. Pull the drawer out slightly
to aid in installing the panel.
2o
} :, }
Install the flat seal washer on the end of the inlet hose.
Connect the inlet hose to the water supply valve. Tighten
securely.
Turn the water valve on and check for any leaks.
metal plate
front panel
tabs
6. Push the front panel down to lock in place.
7. When installed properly, the panel should be even with the top
of the dishwasher.
3. Open the drawer. Remove the packing tape from the front and
rear of dish rack.
4. Close the drawer.