Install The Drain Hose - KitchenAid KUDD01SSSS0 Installation Instructions Manual

Adrain hose extension kit,partno. 8 194400, willextend t hedrain
hose toa length o fupto141%" (360.05 cm). D onotextend
beyond t hislength. The maximum d rain height is371/2"
(95.25 c rn).
Option 1: Sinkdrain
waste tee connection
1. Route the drain hose as shown and press the hose into the
drain hose support.
2. Decide if the drain hose needs to be trimmed. If it does,
trim it.
NOTE: The drain hose connector must not support the weight
3=
4=
of excess hose length. Keep hose as
fully extended as possible.
Slip a wire clip over the drain hose.
Push the hose into the drain hose
connector firmly, 5 clicks.
Position the wire clip between the
two positioning ribs on the drain
hose connector.
_.'b wire clip
drainhose connector
5. Attach the drain hose connector to the waste tee using the
supplied hose clamp.
6. Attach the drain hose support bracket to the cabinet with a
#8 Phillips head screw at the height shown below.
IMPORTANT: A drain loop must be provided as shown in the
Installation Instructions. Keep hoses as fully extended as possible
to prevent sagging. Any excess length of hose should be kept on
the dishwasher side of the drain loop.
drain hose
support ...................
crn)
minimum
waste
_1 waste tee
27-1/2" - 32-1/4"
(70 crn - 82 crn) water supply
rnin. bend
radius from valve
Keep drain hose
straight, as shown.
Option 2: Garbage disposal connection
1. Route the drain hose as shown and press the hose into the
drain hose support.
2. Decide if the drain hose needs to be trimmed. If it does,
trim it.
NOTE: The drain hose connector must not support the
weight of excess hose length. Keep hose as fully extended as
possible.
3. Slip a wire clip over the drain hose.
Push the hose into the drain hose
connector firmly, 5 clicks.
4. Position the wire clip between the
two positioning ribs on the drain
hose connector.
5=
6.
;/_'bwire clip
drainhose connector
Attach the drain hose connector to the garbage disposal
using the supplied hose clamp.
Attach the drain hose support bracket to the cabinet with a
#8 Phillips head screw at the height shown below.
IMPORTANT: A drain loop must be provided as shown in the
Installation Instructions. Keep hoses as fully extended as
possible to prevent sagging. Any excess length of hose
should be kept on the dishwasher side of the drain loop.
drain hose
support
6" (15.2 crn)
rninirnurn
27-1/2" - 32-1/4"
70crn- 82 crn)
water supply
Keep drain hose
straight, as shown.
waste
(20.3 crn) rnin. bend
radius from valve