Denon DN-A7100 User Manual page 12

¤2
A/D button
(When AMP mode is selected)
Used to switch between the analog and digital
inputs.
¤3
TUNING +/– buttons
(When TUNER mode is selected)
Used to tune a frequency station up and down.
¤4
MENU button
(When AMP mode is selected)
This button is used to call up the SETUP MAIN
MENU of the DN-A7100.
¤5
VOLUME +/– buttons
This button is used to adjust the volume for the
amplifi er.
¤6
EXIT button
(When AMP mode is selected)
This button is used to cancel setting in the setup
menu.
¤7
MUTE button
This button is used to mute the audio for the
amplifi er.
¤8
ATT button
(When AMP mode is selected)
When the input signal is too high and the voice
distorts even by throttling the DN-A7100 VOLUME
control, turn on this function.
"ATT" is indicated when this function is activated.
The input level reduced. Attenuator is invalid for the
output signal of "REC OUT".
Note:
This function is unavailable while the digital input is
selected.
¤9
TREBLE +/– buttons
These buttons are used to adjust the tone control of
high frequency sound for left and right speaker.
‹0
T-DISP button
(When TUNER mode is selected)
Used to select the display mode in XM.
‹1
PTY/V-OFF button
(When TUNER mode is selected)
Not used on this unit.
(When AMP mode is selected)
Used to turn off the video signal.
‹2
Infrared Transmitter
This transmitter emits infrared light. Press the
buttons while pointing the transmitter towards the
infrared receiver window of the DN-A7100.
9