Table Of Contents - GE Monogram ZDWT240 Installation Instructions Manual

Safet Information
BEFORE YOU BEGIN:
Read these instructions completelg and carefullg.
I M PORTANT - Sove these instructions
for Iocol inspector's use.
I M PORTANT -Observe
oli
governing
codes
ond ordinonces.
Note to Installer
- Be sure to leove these
instructions with the Consumer.
Note to Consumer - Keep
these instructions with
gour Owner's Monuol for future reference.
WARNING - This
opplionce
must be
properly grounded. See "Grounding", poge 5.
_AVERTISSEMENT -
Cet opporeil doit @trecorrectement mise 5 Io terre.
Consulter <<Mise _ Io terre >>, p oge 5.
If gou received o domoged wine reserve or beveroge
center, gou should immediotelg contoct gour deoler
or builder.
Skill Level - Instollotion requires bosic mechonicol
skills. Proper instollotion is the responsibilitg of the
instoller. Product foilure due to improper instollotion
is not covered under the GE Applionce Worrontg.
_WARNINGS:
• Use this opplionce onlg for its intended purpose.
• Immediatelg repair or replace electrical service cords
that become fraged or damaged.
Unplug the unit before cleaning or making repairs.
Repairs should be made bg a qualified service
technician.
-A AVERTISSEMENT :
• II ne fout utiliser cet opporeil que pour I'usoge pour
lequel il o @t@ construit.
II fout r_porer ou remplocer imm@diotement tout
cordon d'olimentotion @lectriqueeffiloch@ou
endommog&
D@broncherlebor ou le r@frig@roteuro vin ovont
le nettogoge ou toute intervention.
Les r_porotions doivent @trefoites por un technicien
quolifi&
For Monogram local service in gour area,
call 1.800.444.1845
For Monogram service in Canada, call
1.800.561.3344
For Monogram Parts and Accessories, call
1.800.626.2002.
www. monogram.com
CONTENTS
Design Guide
The Instollotion Spoce.............................. 3
Side-bg-Side Instollotions ....................... 4
Product Clearances ................................... /4
Installation Instructions
Tools Required .............................................. 5
Grounding the Product ........................... 5
Staining Wood Drawer Fronts ............. 5
Step 1, Remove Packaging .................... 5
Step 2, Leveling ............................................ 6
Step 3, Connect Power............................. 6
Step 4, Slide Product into Cutout ......... 6
Step 5, Change the Toekick .................... 6
Step 6, Set Temperature Controls ....... 6