Custom Panel Dimensions - KitchenAid KUDS30IVSS4 Installation Instructions Manual

Measure h eight o fcabinet opening fromunderside o f
countertop t ofloorwhere dishwasher will beinstalled
(youwill need to measure t helowest p ointonthe
underside o fthecountertop a ndthehighest pointonthe
floor).Refer to "Dishwasher Height Adjustment Chart"
forwheel p osition andthenumber o fturnsneeded.
opening height position on front leg
33Y8" (8610 cm) Removed All the way Up
I !
34!/4" (87:0 cm) 2 ! 5
NOTE: If the minimum cabinet opening height is less than
34"(86.4 cm), the rear wheels can be removed for
additional clearance. This will allow the dishwasher to fit
into a 337/8 .' (86 cm) high cabinet opening, but the
dishwasher will be more difficult to move. (Measurements
are approximate. Wheels and legs are preset at the
factory for 341/2 .' [87.6 cm].)
Adjust wheels and legs
)
Turn both leveler legs to the same height. Put wheels in
the required position determined from "Dishwasher
Height Adjustment Chart."
Built-up floors: If the kitchen floor is higher than the
cabinet opening's floor - for example, the kitchen floor tile
does not extend into the cabinet opening - add shims as
needed in the area shown to bring the dishwasher up to
34" (86.4 cm) below the countertop.
NOTE: Shims must be securely attached to floor to avoid
movement when the dishwasher is in use.
14
nstall the Door Handle
on some models)
Mounting stud
Handle
Setscrew
(in bottom
of handle)
Allen wrench
IMPORTANT: Do not scratch the front panel during this
procedure.
Remove the door handle and hardware bag containing the
setscrews and Allen wrench from the cardboard box.
Setscrews are already installed in the handle. Place handle
on mounting studs with the setscrews facing down. Push
the door handle tightly against the door. Insert the short
end of the Allen wrench into the setscrews. Tighten the
setscrews 1/4 turn past snug.
Retain Allen wrench with Installation Instructions.
........................................................................................................................................................................................................... iiiiiiiiiiii ¸I¸ifi_i_iii;ii_iii;iiii;ii_iiiiiii ¸iiiii ¸iiiii ¸iiiii ¸iiiiiiiiiii ¸iiiiiiii ¸iiiiiiii ¸iiiiiiii ¸iiiii;ii _iii;iiii;iiii;ii _ii ¸ii;ii _ii ¸ii;ii _ii ¸ii;ii _ii ¸ii;ii _iii;ii_i;ii_i;ii_i;ii_i;ii_i;ii_i;ii_i;ii_i;ii_i;ii_i;ii_i;ii_i;ii_i
Custom Panel Dimensions
IMPORTANT: You need to know which control panel is on
your dishwasher before you order your custom door
panel.
/4" (19.1 mm)
*This dimension is for 4" (10.2 cm) toe kick. If the
installation needs a higher toe kick, adjust the height
of the wood panel accordingly. Not recommended for
toe kicks greater than 6" (15.2 cm).
Follow directions under Option 1 of "Install custom
panel" section.