Install The Door Handle; Custom Panel Dimensions - KitchenAid KUDE40FXBL1 Installation Instructions Manual

Dishwasher Height Adjustment Chart
Minimum Wheel -|Number-.of turns} Perforation
cutout height | position-| -.on-front leg on'blanket
33%" (85.7 cm) | remove' | -all.the way-up remove
3374" (86 cm) remove | all the way up keep
34"(86.4 cm) 1 10 keep
3414" (87-cm) 2 5 keep
3414". (87,6.cm) 3 0 keep}
NOTE: If the minimum cabinet opening height is less than
34" (86.4 cm), the rear wheels can be removed for
additional clearance. This will allow the dishwasher to fit
into a 33%" (86 cm) high cabinet opening, but the
dishwasher will be more difficult to move. (Measurements
are approximate. Wheels and legs are preset at the
factory for 3414" [87.6 cm].) If the minimum cabinet
opening height is 33%" (85.7 cm), a section in the
insulation blanket can be removed by cutting along the
perforation.
Cut insulation blanket along perforation
Turn both leveler legs to the same height. Put wheels in
the required position determined from "Dishwasher
Height Adjustment Chart."
Built-up Floors—Add
shims as needed
Built-up floors: If the kitchen floor is higher than the
cabinet opening's floor - for example, the kitchen floor tile
does not extend into the cabinet opening - add shims as
needed in the area shown to bring the dishwasher up to
34" (86.4 cm) below the countertop.
NOTE: Shims must be securely attached to floor to avoid
movement when the dishwasher is in use.
Install the Door Handle
(on some models)
nstall door handle
Setscrew
(in bottom
of handle)
Hex key
IMPORTANT: Do not scratch the front panel during this
procedure.
Remove the door handle and hardware bag containing the
setscrews and hex key from the cardboard box. Setscrews
are already installed in the handle. Place handle on
mounting studs with the setscrews facing down. Push the
door handle tightly against the door. Insert the short end
of the hex key into the setscrews. Tighten the setscrews 4
turn past snug.
Retain hex key with Installation Instructions.
Custom panel dimensions—Dishwashers
with control panel on the top
2354" ma ~
A
(" (19.1 mm)
* This dimension is for 4" (10.2 cm) toe kick. If the
installation needs a higher toe kick, adjust the height
of the wood panel accordingly. Not recommended for
toe kicks greater than 6" (15.2 cm). J