KitchenAid KGCP487JSS0 Installation Instructions Manual page 5

36" (91.4 cm) and 48" (121.9 cm) professional gas cooktop for residential use only
Hide thumbs Also See for KGCP487JSS0:
Table of Contents

Advertisement

Gas
a
Gas su
Dimensions
3=proagground=type outlet
should he lauated on left hand
side of cutout 8" 20,3 cm)
max=from eric aaare s dewa .
Gas supply line should be
located in this area on rear or
side wails, at the supply line can
came up through the floor,
Gas and Electric
Connection
Locations
Note: Solid sideand
bottomofcataot
enclosure n at shown,
product rating/serial tag
control sopt_t
panel
regulator (
with product) mast be
installed with arrow up
pointing at cooktop
bottom
I/2"nipple
(not supplied)
AGA orUSA approved
flexible stainless
steam gassupplyline
(not supplied)
shut off valve
(not supplied)
36" (91.4 cm)
3-prong ground-type
power supplycard
Typical
Gas
and
Electric
Connections
Copies of the standards listed may be
obtained from:
* CSA hternationat
8501 East P_easant Valley Rd.
C_eveJand, Ohio 44t31-8875
Explosion
Hazard
Use a new AGA or CSA approved
gas supply
line.
Install a shut-off
valve.
Securemy tighten
alt gas
connections.
If connected
to LP, have a
quamified person
make sure gas
pressure
does not exceed 14"
water column.
Examples
of a quamified person
include licensed
heating
personnel,
authorized
gas
company
personnel,
and
authorized
service
personnel
Failure to do so can result in
death, explosion,
or fire.
Observe aH governing
codes and
ordinances.
important:
Cooktop must be connected
to a regulated gas supply.
installation must conform with
local codes and ordinances, in the
absence of local codes, installations must
conform with American National
Standard, National Fuel Gas Code
ANSI Z223.1 -- latest edition or
CANI -- B149.1 or 2".
E input ratings shown on the
model/serial rating plate are for elevations
up to 2,000 feet (610 m). For elevations
above 2,000 feet (610 m), ratings are
reduced at a rate of 4% for each 1,000
feet (305 m) above sea level.
C
mThe cooktop is equipped for use
with NATURAL gas. it is design=certified
by International Approval Services (I.A.S.)
for NATURAL and LR gases with
appropriate conversion. The model/serial
rating plate, located on the underside of
the burner box, has information on the
type of gas that can be used. if this
information does not agree with the type
of gas available, check with the local gas
supplier.

Advertisement

Table of Contents
loading

This manual is also suitable for:

Kgcp467jtl0

Table of Contents