Built-Inoven Safety; Installation Requirements; Tools And Parts; Electrical Requirements - KitchenAid KEHU309SSS03 Installation Instructions Manual

BUILT-INOVEN SAFETY
Your safety and the safety of others are very important.
We have provided many important safety messages in this manual and on your appliance. Always read and obey all safety
messages.
This is the safety alert symbol.
This symbol alerts you to potential hazards that can kill or hurt you and others.
All safety messages will follow the safety alert symbol and either the word "DANGER" or "WARNING."
These words mean:
You can be killed or seriously injured if you don't immediately
follow instructions.
You can be killed or seriously injured if you don't follow
instructions.
All safety messages will tell you what the potential hazard is, tell you how to reduce the chance of injury, and tell you what can
happen if the instructions are not followed.
INSTALLATION REQUIREMENTS
"tbos csnd
Gather the required tools and parts before starting installation.
Read and follow the instructions provided with any tools listed
here.
Tools needed
• Adjustable wrench or %" wrench
• Phillips screwdriver
• Flat-blade screwdriver
• Measuring tape
• Hand or electric drill (for wall cabinet installations)
• 1" (25 mm) drill bit (for wall cabinet installations)
• Level
• Copper tubing cutter
Parts supplied (1 box, 3 plastic bags)
• One - 3/8"stem to 1/4"quick connect
• Two - 3/8"elbow to 1/4"quick connects
• Water filter
• #10-16 x %" screw and 1 mounting ring (to mount water filter)
• #8-14 x 1" screws - single oven (2), double oven (4)
• Bottom vent (supplied on some models)
• #8-18 x 3/8"screws - bottom vent (supplied on some models)
Parts needed
• UL listed or CSA approved conduit connector
• UL listed wire connectors
• Tubing staples/retainers
NOTE: Due to temperatures around oven, copper tubing is
required.
• Water connection device (to connect 1¼,, O .D. copper tubing
to water source). Check local codes for type of connection
required.
• 1_" to 1¼"water supply union (between copper tubing from the
filter and copper tubing attached to oven).
Check local codes. Check existing electrical supply. See
"Electrical Requirements."
It is recommended that all electrical connections be made by a
licensed, qualified electrical installer.
IMPORTANT: Observe all governing codes and ordinances.
• Cabinet opening dimensions that are shown must be used.
Given dimensions provide minimum clearance with oven.
• Recessed installation area must provide complete enclosure
around the recessed portion of the oven.
• Grounded electrical supply is required. See "Electrical
Requirements" section.
• Electrical supply junction box should be located 3" (7.6 cm)
maximum below the support surface when the oven is
installed in a wall cabinet. A 1" (2.5 cm) minimum diameter
hole should have been drilled in the right rear or left rear
corner of the support surface to pass the appliance cable
through to the junction box.
• Oven support surface must be solid, level and flush with
bottom of cabinet cutout. Floor must be able to support a
total weight (microwave and built-in oven) of 238 Ibs (108 kg).
• 1¼.O.D. copper tubing (to make water connection)
2