Table of Contents
Advertisement
05651238.qxd
29-05-02
Testing the installation
Refer to the programme guide for details of how to select programmes.
For stopping each programme before its completion, the programme must be
cancelled by holding down the START/PAUSE button for five seconds. The display
will inform you that the programme has been cancelled.
1. Turn on the water supply and check for leaks from fill hoses.
2. Switch on the electricity supply.
3. Select spin programme 15 and then press the Start button to start the
machine. Allow the programme to continue for one minute and then cancel the
programme (Please see 'Description of controls' section for cancelling the
programme). This will remove any water remaining in the machine from factory
testing.
4. To check for cold water filling to the machine:
Select a rinse programme and press the Start button to start the machine.
Allow the tumble action to continue until the water has pumped out.
Check that the drain outlet is not leaking or overflowing.
5. Switch off the machine at the end of the cycle by turning the control knob to
the OFF position.
6. To check for hot water filling to the machine:
Select programme 2 and press the Start button to start the machine.
Allow the wash action to continue for one minute, then cancel the programme.
Alternatively, both inlets can be connected to the cold water supply by using a
suitable adaptor.
7. Select spin programme 15 and press the Start button to switch the machine
on. If the machine takes longer than one minute to empty check the drain
hoses for kinks.
Installation testing is now complete.
10:10
Page 9
9
Advertisement
Table of Contents
