Testing The Installation - Hoover HP 16 E Instructions For Use Manual

40000650-Eng.qxd 07/10/2003

Testing the installation

Refer to the programme guide for details of how to select programmes.
1. Turn on the water supply and check for leaks from fill hoses.
2. Switch on the electricity supply.
3. Select a spin programme and then press the START/PAUZE button to start the
machine.
Allow the programme to continue for one minute and then cancel the
programme (please refer to "Description of Controls" section for cancelling the
programme). This will remove any water remaining in the machine from factory
testing.
4. To check for cold water filling to the machine:
Select a rinse programme and press the START/PAUZE button to start the
machine.
Allow the tumble action to continue until the water has pumped out.
Check that the drain outlet is not leaking or overflowing.
5. Switch off the machine at the end of the cycle by turning the programme knob
to the "OFF" position.
6. If the machine takes longer than one minute to empty check the drain hoses
for kinks.
Installation testing is now complete.
14:23 Page 9
9