Wake To Alarm; Snooze Operation; Battery Low Indicator - Timex Jelly Clock T116 Instruction Manual

Wake to Alarm

After setting the alarm time(s), you can press the Alarm 1 or Alarm 2 button to
arm or disarm the associated alarm. The Alarm Indicator Icon(s) will appear on
the display, showing that the alarm is armed and will sound at the displayed
time.
After the alarm sounds, press the Alarm Reset Button to turn it off and automatically
reset it for the same time the following day.
To turn off the alarm without setting it for the following day, just press the armed
alarm button again. The Alarm Indicator Icon will disappear.
NOTE: The alarm will sound for approximately 1 hour and then turn off
automatically. This cycle will repeat every 24 hours unless the controls are
changed.

Snooze Operation

During normal operation, press the Snooze button once to adjust the LCD
backlight brightness to Hi, Med, Lo or Off.
To program the snooze time, just press and hold the Snooze/Dimmer Button
until the display shows the current snooze time (default is 9 minutes). Press the
+ Button and - Button to adjust snooze time from 1 to 30 minutes. Press the
Snooze/Dimmer Button again. Two beeps will confirm the snooze time is set.
Press the Snooze/Dimmer Button when the alarm sounds to shut off the alarm
for the programmed amount of snooze time before sounding again. You may
repeat this several times during the one-hour alarm cycle.

Battery Low indicator

The Battery Low Indicator is located on the lower left corner of the display and
will flash if backup batteries are low and need to be replaced with fresh batteries.
4