Advertisement
Quick Links
Read this before you start.
TOOLS
needed for installation:
• Cutting knife
• Channel
lock
• Nut driver
• Level
• Crescent
wrench
Proper installation
is the responsibility
of the purchaser.
SERVICE
CALLS
PERFORMED
AS A RESULT
OF POOR INSTALLATION
ARE THE
RESPONSIBILITY
OF THE INSTALLER.
Make sure you have everything
necessary
for proper installation.
@
GROUNDED
ELECTRICAL
OUTLETS
are required.
See Electrical
Requirements.
STANDPIPE
DRAIN SYSTEM
must be able to accept
1-1/2 inch O.D. drain hose.
Standpipe
height of 36 inches is recommended.
The drain must permit 23 gallon per
minute flow to evacuate
the washer.
NOTE:
If the standpipe
height is less than 3 feet or greater than 5 feet, refer to the
"DRAIN FACILITY"
section to determine
if special provisions
are needed.
HOT AND COLD WATER FAUCETS
must be within 4 feet of the back of the washer.
NOTE:
For installations
requiring
longer hose length, it is recommended
to purchase
a
double male 3/4" NH coupling
and Maytag hose #33-7046
or equivalent.
WATER HEATER
set to deliver
140°F (60°C) hot water to the washer.
PROTECTION
FROM WEATHER:
Do not store or operate washer
below 60°F (15°C).
PARTS supplied
for installation:
Cable tie to secure drain hose to standpipe,
inlet hose or laundry tub
2 washers
and 2 screens for water hoses
Advertisement
Related Manuals for Maytag MAV9501EWW
Summary of Contents for Maytag MAV9501EWW
- Page 1 4 feet of the back of the washer. NOTE: For installations requiring longer hose length, it is recommended to purchase double male 3/4" NH coupling and Maytag hose #33-7046 or equivalent. WATER HEATER set to deliver 140°F (60°C) hot water to the washer. PROTECTION FROM WEATHER: Do not store or operate washer below 60°F (15°C).
- Page 2 (Part No. 12001875) containing accessory ground wire, clamp, ground screw and washer can be purchased. Contact your authorized Maytag dealer for further assistance. Follow ALL grounding requirements codes. A proper external ground MUST be determined prior to wire hookup. Consult local building...
- Page 3 6. 30 day detergent dispenser should be be obtained (Part No. 12001585). If a high- completely emptied (on models so volume pump is purchased, the extension kit is equipped). included. Contact your authorized Maytag dealer for further assistance.
- Page 4 Remove parts and literature from inside of washer Start here... Step 1 • Remove the carton by cutting only marked areas of the carton. CAUTION: Hoses are connected to the washer. NOTE: If the washer is moved without the Step 4 carton in place, be sure to keep sharp edges from damaging the washer...
-
Page 5: Ground Screw
,. With the tub block in place, retape the lid. After ins1 • Improper connection the equipment-grounding STAtIOPFP_ conductor can result in a risk of electrical shock. Check with a qualified electrician or serviceman if you are in doubt as to whether the appliance properly... - Page 6 lation is completed, be sure to remove tub block. LOCK NUT Step 12 Once the machine is level, tighten both front leveling leg locking nuts with a wrench. Once again, reset the rear stabilizer as described Step 10. On models equipped with a felt sound deflector under the front of the machine,...