Kenmore 79097502002 Installation Instructions Manual

30" electric range

Advertisement

Available languages

Available languages

Quick Links

iNSTALLATiON AND SERVICE MUST BE PERFORMED BY A QUALiFiED iNSTALLER.
iMPORTANT:
SAVE FOR LOCAL ELECTRICAL
iNSPECTOR'S
USE.
READ AND SAVE THESE iNSTRUCTiONS
FOR FUTURE REFERENCE.
pr_
FOR YOUR SAFETY: Do
nat store or use gasollne
or other flammable
vapors
and
liquids
in the vicinity
of this or any other appllance.
. Clearances
and Dimensions
a. Provide adequate
clearances
between
the range and adjacent
combustible
surfaces.
b. Location--Check
location
where the range will be installed. Check for proper electrical
supply and the stability of floor.
c. Dimensions
that
are shown must be used. Given
dimensions
provide
minimum
clearance.
Contact
surface
must be
solid and level.
FRONT
.......
TYPICAL
CABINET
INSTALLATION
SIDE
wall
on either
|"
I1_
side of range
above
91,4cm
(36")
height.
l_ao
I/a"_l
76,2 cm (30") minimum
clearance
between
the top of the cooking
surface and the bottom
of an unprotected
wood or metal
cabinet;
or 61 cm (24") minimum
when bottom
of wood or metal cabinet
is
protected
by not less than 0,64 cm (1/4") flame
retardant
millboard
covered
with not less than no. 28 MSG sheet steel, 0,038 cm (0,015")
stainless steel, 0,061 cm (0,024")
aluminum
or 0,051 cm (0,020")
copper. The minimum
clearance
is 0 cm (0") for the rear of the
range. Follow all dimension
requirements
provided
above to prevent
property
damage,
potential
fire hazard,
and incorrect
countertop
and cabinet
cuts.
Avoid locating
cabinet storage space above the surface units to
ellmlnate fhe possibility of cabinets cafchlng on fire, or personal
burns from reaching for fhe cabinets over fhe healed
unifs. If cabinet
sforage
is lo be provided,
risk can be reduced by inslalllng a range
hood fhaf projects horizontally
a minimum
of 5" beyond
the bottom
of
the cabinets.
Imporlanl
Noles Io lhe Inslaller
1.
Read all instructions
contained
in these installation
instructions
before installing
the appliance.
2.
Remove all packing
material
before connecting
the electrical
supply to the appliance.
3.
Observe
all governing
codes and ordinances.
4.
Be sure to leave these instructions
with the consumer.
Printed
in Canada
T
124,5cm
49"
Maximum
116,8
cLX
46"
Dooropen
\
\
91,4-+0,3cm
18 n
7 cm
(2W')
BACK
...... _
_
l_li dimensions
:
lectrical outlet _*-_"_
.....
N--_ -r -_re
maximum.
_
_
_
_
"I
Cubed area shows where
the electricaloutlet must
be installedfor the range
i
to be flush to the wall.
7,6c_-
(3'/
Important
Note
_o the Consumer
Keep these instructions with your Use and Care
Guide for future reference.
318201733 (1202) Rev. C

Advertisement

Table of Contents
loading

Summary of Contents for Kenmore 79097502002

  • Page 1 iNSTALLATiON AND SERVICE MUST BE PERFORMED BY A QUALiFiED iNSTALLER. iMPORTANT: SAVE FOR LOCAL ELECTRICAL iNSPECTOR'S USE. READ AND SAVE THESE iNSTRUCTiONS FOR FUTURE REFERENCE. FOR YOUR SAFETY: Do nat store or use gasollne or other flammable vapors liquids in the vicinity of this or any other appllance.
  • Page 2: Tools You Will Need

    2. Tools You Will Need Tip Over Hazard For leveling legs and Anti-Tip Bracket: * A child or adult can tip the range • Adjustable wrench or channel loci< pliers and be killed. ° 5/16" Nutdriver or Flat Head Screwdriver * Verify the anti-tip device has °...
  • Page 3 B. Drlll Pilaf Holes and Fasten Bracket = Drill a 1/8" C. Level and position the rancj__= Slide range to pilot hole where screws are to be located. If bracket its final position. Insert the range leveling leg in is to be mounted to the wall, drill pilot hole at an the anti-tip bracket.
  • Page 4: Checking Operation

    4. Serial Plafe Inforrnafion 6. Checking Operation The serial plate is located Refer to the Use and Care Guide for operation. as shown below. See the Do not touch cooktop glass or serial plate for the following elements. They may be hot enough to burn you. information: Model, lot and serial...
  • Page 5: Notes Importantes

    L'iNSTALLATION ET L'ENTRETIEN DOIVENT ETRE EFFECTUES PAR UN INSTALLATEUR QUALIR| 5. iMPORTANT: CONSERVEZ POUR L'INSPECTEUR D'_:LECTRICIT_: LOCAL. LiSEZ ET CONSERVEZ CES iNSTRUCTiONS POUR R_:F_:RENCES ULT_:RIEURES. POUR VOTRE SI]CURITE: N'entreposez pas ou n'utilisez pas d'essence ou d'oufres produifs inflammables 6 proxlmlf_ de cat apparell ou de tout oufre opparell _lectrom_nager.
  • Page 6 2. Oufils requis: Risque de basculernent Pour les pattes de nivellement et le support anti-bacule: * Un enfant ou un adulte peut ° Cl_ & molette ou pince r_glabie. faire basculer la cuisini_re et en ° 5/16" Tournevis & douille ou d6c6der.
  • Page 7 B. Percez des avanl=trous el fixez le support = C. Mise _ nlveau el posillonnemenl de la culslni_re. Rep6rez le centre des trous indiqu6s et percez des Glissez la cuisini_re 6 son emplacement final. Ins6rez avant-trous de 1/8". Si le support dolt 6tre fix6 au la patte de nivellement de la cuJsini@re dans...
  • Page 8 6. V_riflcation du Foncfionnement 4.1nformaEon concernant la plaque de s_rie La plaque de s6rie est R6f6rez-vous au Manuel d'utitisation et d'entretien situ6e tel que montr6 plus fourni avec la cuisini@re pour les directives bas. Les informations fonctionnement d'entretien et de nettoyage. suivantes s'y trouvent: Ne touchez pas aux 616ments.

This manual is also suitable for:

79097509002

Table of Contents