Complete Installation Checklist - Kenmore 11021302012 Installation Instructions Manual

f14. Adjust leveling feet
If washer is not level, use a 9/16" or 14 mm open-end or
adjustable wrench to turn jam nuts clockwise on feet until they
are about 1/2" (13 mm) from the washer cabinet. Then turn the
leveling foot clockwise to lower the washer or counterclockwise
to raise the washer. Recheck levelness of washer and repeat
as needed.
HELPFUL TIP: You may want to prop up front of washer
about 4" (102 ram) with a wood block or similar object that
will support weight of washer.
5. Tighten leveling feet
When washer is level, use a 9/16" or 14 mm open-end or
adjustable wrench to turn jam nuts counterclockwise on
leveling feet tightly against washer cabinet.
HELPFUL TIP: You may want to prop washer with
wooden block.
8
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter,
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
1 6. Plug into a grounded 3 prong outlet
COMPLETE NSTALLATmON
CHECKLmST
Check electrical requirements. Be sure you have correct
electrical supply and recommended grounding method.
Check that all parts are now installed. If there is an extra
part, go back through steps to see what was skipped.
Check that you have all of your tools.
Check that any shipping materials were completely
removed from washer.
Check that water faucets are on.
Check for leaks around faucets and inlet hoses.
Remove protective film from console and any tape
remaining on washer.
Check that washer is plugged into a grounded
3 prong outlet.
Dispose of/recycle all packaging materials.
Read "Washer Use" in your Washer User Instructions.
To test and clean your washer, measure 1/2 of normal
recommended amount of powdered or liquid detergent
and pour it into washer basket or detergent dispenser
(on some models). Close lid. Select any cycle. Start washer
and allow to complete full cycle.