Mitsubishi Electric Mr. SLim SEZ-KD09NA Installation Manual page 6

8 8.2
[Fig. 8-3]
(_ Indoor terminal block
@L-----J L_ b [AWG16] or more
Outdo o
@ Power supply cord
(8) Indoor terminal block
C_ Ground wire (green/yellow)
Cc_Indoor/outdoor unit connecting cable 3-
core 1.5 mm 2 [AWG 16] or more
(_) Outdoor terminal block
C_,Power supply cord
O Indoor/outdoor unit connecting cable 3-
core 1.5 mm 2 [AWG 16] or more, fol-
lowing Design 245 IEC 57.
(D Indoor terminal block
@ Outdoor terminal block
@ Always install an ground wire (1-core
1.5 mm 2[AWG 16]) longer than other cables
@ Remote controller cable
Wire No x size (mm 2) : Cable 2C × 0.3
Accessory wire of remote controller
(wire length : 10m [32 ft], non-polar. Max. 500 m
[1640 ft])
O Wired remote controller
(_ Power supply cord
[Fig. 8-4]
8.3
__ CE;_ iUnit: mm [in])
(8) Remote controller
C_ Required clearances for the remote controller
Cc_Installation pitch
[Fig. 8-5]
@ B-1.
®
@ For installation in the switch box:
CB_For direct installation on the wall, select one of the following:
• Prepare a hole through the wall to pass the remote controller cord (in order to run the remote controller cord from
the back), then seal the hole with putty.
• Run the remote controller cord through the cut-out upper case, then seal the cut-out notch with putty similarly as
above.
C© Wall
(_) Conduit
C_,Lock nut
@_Bushing
Switch box
CA_ Remote controller cord
Ci_ Seal with putty
CJ_Wood screw
[Fig. 8-6]
(_ To the terminal block on the indoor unit
C_ TB6 (No polarity)
®
[Fig. 8-7]
8.4
6 4_
"_-',-_-I
&,
(_ Mode number
(_ Setting number
(_ Refrigerant address
(_ Unit number
(_ Filter .I button (<Enter> button)
C_ TEST button
C© Set Time button
(_) Timer On/Off button (Set Day button)
C_,Mode selection button
_ Set temperature button
Timer Menu button (Monitor/Set button)
6