Table of Contents
Advertisement
Introduction
Installation- Keyboard Wedge
1)
Disconnect power to the terminal/computer.
2)
Disconnect the keyboard cable from the back of the
terminal/computer and connect to the interface cable of
the scanner.
3)
Connect the interface cable of the scanner to the
terminal/computer.
4)
Turn the terminal/computer power on.
RS-232
1)
Disconnect power to the terminal/computer.
2)
Connect the external power supply (DC adapter) to the
interface cable of the scanner.
3)
Plug the serial connector into the serial port on the back
of your computer/terminal. Tighten the two screws to
secure the connector to the port.
4)
Plug the power pack into a power source.
5)
Once the scanner has been fully connected, turn the
terminal/computer power back on.
USB (Simulates keyboard wedge)
1)
Connect the USB cable to the terminal/computer.
2)
Windows will automatically detect the USB device.
Note: If the scanner does not operate, turn off the power
immediately and check any improper connections. Go
through all of the above steps again.
4
Hide quick links:
Advertisement
Table of Contents
