Installation Diagram - Mitsubishi Electric MSZ-FE18NA Installation Manual

1-4. INSTALLATION DIAGRAM
ACCESSORIES
Check the following parts before installation.
<Indoor unit>
(1) ilnstallation plate 1
Attachment screws for the installa-
(2) lion plate 7
i4 x 25 mm
(3) Remote controller holder 1
Screws for the remote controller
(4) holder 2
i3.5 x t6 mm (Black)
(5) Battery (AAA) for (6) 2
(6) Wireless remote controller 1
Felt tape
(7) i(Fo r left or left-rear piping) 1
(8) iAir cleaning filter 2
FIELD-SUPPLIED PARTS
(A) Indoor/outdoor unit connecting wire * 1
(B) Extension pipe t
(C) Wall hole sleeve 1
(D) Wall hole cover 1
(E) Pipe attachment strap 2t0 5
(F) Screw for (E) 4 x 20 mm 2t0 5
(G) Piping tape 1
(H) Putty 1
Drain hose
(or soft PVC hose, 19/32 in. [15 1 0r2
(I) mm] inner diameter or hard PVC
pipe VP16)
(J) Refrigerant oil 1
(K) Power supply cord * 1
• Note:
Place indoor/outdoor unit connecting wire (A)
and power supply cord (K) at least 3 ft. (1 m)
away from the TV antenna wire.
f
Use the wall hole sleeve
(C) to prevent indoor/out-
door connecting wire (A)
from contacting metal
parts in the wall and to
protect the wiring from
rodents.
I_L_J WalI hole cover (D)
Indoor unrt _:_Seal the wail hole ]
Wail hole _/_f f .....................
Cut off the Pipe fixing band
extra 'ength._ (E)
Fixing
screw (F)
(1)
X(4)
'(A)
leak test, apply insulating mate-
rial tightly so that there is no gap.
is to be attached to a wall
comprised of tin plate or metal netting, use
chemically treated wooden piece 25/32 in.
(20 mm) or thicker between the wall and
the piping, or wrap insulation vinyl tape 7
to 8 turns around the piping.
To use existing piping, perform COOL
operation for 30 minutes and pump down
before removing the old air conditioner.
Remake flare according to the dimension
for new refrigerant.
Outdoor unit installation
Unit: inch
i_ 33-1/16 "4
_* __4_Air outlet_
2-3/8 x 13/16 slot 1-9/16
Unit: mm
/, _Arr outlet _
2-10 x 21 slot 40
Units should be installed by licensed contractor
accord ng to oca code requ rements.
Drain piping for outdoor unit
Install the unit horizontally.
Do not use drain socket in cold regions. Drain may freeze and make the fan stop.
The outdoor unit produces condensate during the heating operation. Select the installation place to ensure to prevent the outdoor unit and/or the grounds from being wet by drain
water or damaged by frozen drain water.