Payne PA1P048 Installation & Start-Up Instructions page 24

30 40 50 50 ?0 80 90
SUCTION LINE TEMPERATURE (_F}
I I I I I I I
4 10 18 21 27 32
SUCTION LINE TEMPERATURE ('C)
7581 I 1 0
6891 100
621 90
< m
o_ Is
ss21_0
crl
w I m
cd I_
W Is
Iz
w
z414 zSO
z I_
o ID
Lr_
o 3451 50
2761 40
OUTDOOR TEI4P
F C
115 46
105 41
95 35
85 29
75 24
65 18
55 13
45 7
3O
30 40 SO BO 70 80 90
SUCTION LINE TEHPERATURE (°F}
I I I I I I I
4 10 18 21 27 32
SUOTION L]NE rEMPERATURE ("C)
!9--Coolinc PAl P042 Units O99041 20--CoDlin(
PAl
P048
Unit_ 99042
(024) 60HZ CHARGING CHART
30 40 SO 80 70 80 90 30 40 50 50 70 80 90
SUCTION LINE TEMPERATURE ((F} SUCTION LINE TEMPERArURE {°F)
I I I I I I I I I I I I I I
4 10 I 5 21 27 32 4 I 0 1 6 2/ 27 32
SUCTION LINE rEkIPERATURE ("C) SUCHON LINE TENPERATURE ('C)
Fig. 22--Cooling Charging Chart, PA2P024 Un[t_ 99044
Straighten bent fins with a fin comb. It" coated with dirt or lint, clean the coils with a vacuum cleaner, using the soft blT_/sh attachment. Be card:'ul
not to bend the fins. If coated with oil or grease, clean the coils with a mild detergentoand-water solution. Rinse coils with clear water, using a
garden hose. Be card:'ul not to splash water on motors, insulation, wiring, or air _ter(s). For best results, spray condenser coil fins fi'om inside
to outside the unit. On units with an outer and inner condenser coil, be sure to clean between the coils. Be sure to flush all dirt and debris fiom
the unit base
Inspect the &ain pan and condensate drain line when inspecting the coils Clean the &ain pan and condensate drain by removing all foreign matter
fiom the pan. Flush the pan and drain robe with clear water. Do not splash water on the insulation, motor, wiring, or air filter(s). If the drain tube
is restricted, clear it with a "plumbers snake" or similar probe device Ensure that the auxiliary &ain port above the drain tube is also clear
Q. CONDENSER FAN
Fig. 21--Cooling Charging Chart, PAIP060 Units
A CAUTION: Keep the condenser fan free from al! obstructions to ensure proper cooling operation. Never place articles
on top of the unit. Damage to unit may result.
1. Remove 6 screws holding condenser grille and motor to top cover.
2. Turn motor grille assembly upside doN',n on top cover to expose the f_n blade.
24