Table of Contents
Advertisement
Installation
Instructions
C._.RECIRCULATING
(Non-Vented
Ductless)
INSTALLATION
OVERVIEW
01. Attach
Mounting
Plate to Wall
02. Prepare Top Cabinet
03. Check Microwave
Assembly
04. Adjust
Blower
05. Mount the Microwave
Oven
06. Install Charcoal
Filter
01_ ATTACH THE MOUNTING
PLATE
TO THE WALL
===B
Attach the plate to the wall using toggle bolts. At least
one wood screw must be used to attach the plate to
a wall stud.
1. Remove
the toggle wings from the bolts.
2. Insert the bolts into the mounting
plate through
the holes designated
to go into drywall
and
reattach
the toggle wings to 3/_,, onto each bolt.
To use toggle
bolts:
Mounting
Plate
Spacing for Toggles More
__1.__,_! T.___han
Wall Thickness
I
i Toggle Wings
Bolt End
3. Place the mounting
plate against the wall and
insert the toggle wings into the holes in the wall to
mount the plate.
NOTE:
Before tightening
toggle bolts and wood
screw, make sure the tabs on the mounting
plate
touch the bottom
of the cabinet
when pushed
flush
against the wall and that the plate is properly
centered
under the cabinet.
CAUTION:
Be careful to avoid pinching
fingers
between
the back of the mounting
plate and the wall.
4. Tighten
all bolts. Pull the plate away from the wall
to help tighten the bolts.
02_
USE TOP CABINET
TEMPLATE
FOR PREPARATION
OF TOP
CABINET
You need to drill holes for the top support screws and
a hole large enough
for the power cord to fit through.
•
Read the instructions
on the TOP CABINET
TEMPLATE.
•
Tape it underneath
the top cabinet.
•
Drill the holes, following
the instructions
on the
TOP CABINET
TEMPLATE.
CAUTION:
Wear safety goggles
when drilling holes
in the cabinet bottom.
19
Advertisement
Table of Contents
