Table of Contents
Advertisement
Step-by-step installation guide
A. OUTSIDE TOP EXHAUST (VERTICAL DUCT)
A1. INSTALLATION PROCEDURE
FOR EXHAUST ADAPTOR AND
PROPER DAMPER OPERATION
CHECK
Blower Plate
Retaining Hooks
1.
Slide exhaust adaptor following the instructions
show in diagram.
2.
Make sure tape securing damper is removed
and damper pivots easily before mounting
microwave.
•
You will need to make adjustments to assure
proper alignment with your house exhaust duct
after the microwave is installed.
A2. ADJUST THE EXHAUST ADAPTOR
Open the top cabinet and adjust the exhaust adaptor
to connect to the house duct.
Damper
For Side-toSide
Adjustment,
Slide the Exhaust
Adaptor as Needed
ME4000R_ME17R7021EB_AA_DE68-04584A-00_EN.indd 12
NOTE: The house duct is needed to connect to the
exhaust adaptor after installation completion.
Damper
Exhaust Adaptor
Back of
Microwave
Oven
B. RECIRCULATING (NON-
B1. ADAPTING MICROWAVE BLOWER
1.
2.
Back of
Microwave
Oven
NOTE: The exhaust adaptor with damper is not
needed for recirculating models. You may want to
save them for possible future use.
3.
CAUTION: Do not touch blade of blower for
preventing crack and break. Hold outer case when
the blower pull out or back into.
12
House Duct
VENTED DUCTLESS)
FOR RECIRCULATION
Remove and save screw that holds blower plate
to microwave.
Lift up the blower plate.
Back of
Microwave Oven
Remove screw holds blower mortor and carefully
pull out the blower unit. The wires will extend far
enough to allow you to adjust the blower unit.
Blower
Retaining
Screws
6/19/2019 4:17:40 PM
Advertisement
Table of Contents
