Sony VPL-CX76 Operating Instructions Manual page 14

x Changing the settings
When you select [Setup] from the action menu, the [Network Setting] window of the selected
mode is displayed, where [Internet Protocol(IP)], [Wireless Network], and [802.1x
Authentication] settings can be changed. Select the desired item and press the ENTER (or
right) key to activate its setting items. To input the desired value for the items, press the ENTER
(or right) key. You can return to the setting menu with the ENTER (or left) key. Click [OK] to
save the settings and return to the initial display of the Air Shot 2 setting menu. If you select
[Cancel], the settings will not be saved and the initial display of the Air Shot 2 appears.
*: Disabled in Simple Mode
Items
Internet Protocol(IP)*
IP Address Setting
IP Address
Subnet Mask
Default Gateway
Primary DNS
Secondary DNS
Wireless Network
Network Mode*
Network Name(SSID)*
Network Authentication*
Data Encryption*
14
Wireless Connection
Functions
Specify the [Internet Protocol(IP)] settings: [IP Address
Setting (Manual/Auto)], [IP Address], [Subnet Mask],
[Default Gateway], [Primary DNS], [Secondary DNS].
IP Address Setting: select [Auto(DHCP)] or
[Manual].When the [Manual] is selected, set [IP Address],
[Subnet Mask] and [Default Gateway].
Set the IP address for the projector.
(1.0.0.0~223.255.255.255)
Set the subnet mask for the projector.
(0.0.0.0~255.255.255.255)
Set the default gateway for the projector.
(1.0.0.0 ~223.255.255.255)
Set the primary DNS server. (1.0.0.0~223.255.255.255)
Set the secondary DNS server. (1.0.0.0~223.255.255.255)
Set in the [Wireless Network] window: [Network Mode],
[Network Name(SSID)], [Network Authentication], [Data
Encryption], [Key], and [Channel].
Select [Ad-hoc(Peer-to-peer)] or [Wireless Access Point]
• Ad-hoc(Peer-to-peer): for wireless LAN connection
without the access point
• Wireless Access Point: for wireless LAN connection with
the access point
Enter the same network name as that of the connected
computer or access point. A maximum of 32 characters/
numbers can be entered.
Select the network authentication system from among
[Open], [Shared], [WPA], and [WPA-PSK].
Select the data encryption system from among [WEP] or
[TKIP]. If the data encryption is not used, select [Disable].