Description Of Controls - Hoover OPH 716 DF Instructions For Use Manual

Description of controls

Fig. 1
P
Door handle
"Door Security" indicator light
"Start/Pause" button
"Cold Wash" button
"Sensitive Care" button
"Delay Start" button
"Spin Speed" button
Digital display
Buttons indicator light
Programme selector with "OFF" position
Detergent drawer
C H G MD N
B F M E
A
A
B
C
D
E
F
G
H
M
N
P
6
Door handle
Press the finger-bar inside the door handle to open the door.
"DOOR SECURITY" indicator light
The "Door Security" indicator light is illuminated when the door is fully closed and the machine is ON.
When "Start/Pause" is pressed on the machine with the door closed the indicator will flash
momentarily and then illuminate.
If the door is not closed the indicator will continue to flash.
A special safety device prevents the door from being opened immediately after the end of the cycle.
Wait for 2 minutes after the wash cycle has finished and the "Door Security" light has gone out
before opening the door. At the end of the cycle turn the programme selector to "OFF" .
"START/PAUSE" button
Press to start the selected cycle .
NOTE: When the "Start/Pause" button has been pressed,
the appliance can take few seconds before it starts
working.
Changing the settings after the programmes has started (PAUSE)
Press and hold the "START/PAUSE" button for about 2 seconds, the flashing lights on the
options buttons and time remaining indicator will show that the machine has been paused,
adjust as required and press the "START/PAUSE" button again to cancel the flashing lights.
If you wish to add or remove items during washing, wait 2 minutes until the safety device
unlocks the door.
When you have carried out the manoeuvre, close the door, press "Start/Pause" button and
the appliance will continue working where it left off.
CANCELLING THE PROGRAMME
To cancel the programme, set the selector to the OFF position.
Select a different programme.
Re-set the programme selector to the OFF position.
7
A
B
C