Advertisement
28,
Screw
in leveling
legs
diamond
marking
Examine leveling legs, find diamond marking. Screw legs into
leg holes by hand, use a wrench to finish turning legs until
diamond marking is no longer visible.
CONNECT
_NT
29,
Connect vent to exhaust
outlet
\
Using a 4" (102 mm) clamp, connect vent to exhaust outlet
in dryer. If connecting to existing vent, make sure vent is clean.
Dryer vent must fit over dryer exhaust outlet and inside exhaust
hood. Check that vent is secured to exhaust hood with a 4"
(102 mm) clamp.
Place
level here
Check levelness of dryer from side to side. Repeat from
front to back.
Not Level
LEVEL
Not Level
32.
Tighten and adjust
leveling
legs
If dryer is not level, prop up using a wood block, use wrench
to adjust legs up or down, and check again for levelness. Once
legs are level, make sure all four legs are snug against the
ground before tightening them.
Move dryer to final location, taking care not to crush or kink vent.
After dryer is in place, remove corner posts and cardboard from
under dryer.
14
Advertisement
