Whirlpool MH6300XM0 Installation Instructions Manual page 8

4
MOUNTING
OVEN
BACK SUPPORT
CAUTION: Be sure to remove packing tape on
damper. The unit is shipped assembled for top
exhaust.
Select directions for mounting back support based on
type of venting being used.
A. Outside venting through top surface of unit.
1. Lift back support into place. Secure to wall with
four (4) 1/4" x 1-1/2" bolts in the corners of back
support. (See figure 19.)
Jly" JI
• °
_P RADJUSTMEN'[\/ III II
PATTERN SCREWS "_ _11 II
BAC SOPPOR o, II
Figure 19
2.
.
If adjustment is needed to center damper in
cabinet cutout, loosen four (4) screws shown in
(Figure 19), center damper and retighten.
Screw at least one 1/4" x 2" long lag screw into
stud and tighten. (In the center hole pattern.)
CAUTION: Damper flap must swing freely.
B. Outside venting through back.
1. Remove damper and damper support by remov-
ing four (4) screws. (See figure 20).
II
k _ DAMPER_
" ' " ' _"i__S!RE!J: Figure 20
.
,
.
Lift back support into place. Secure to wall with
four (4) 1/4" x 1-1/2" bolts in each corner of the
back support. (See figure 21.)
Screw at least one 1/4" x 2" long lag screw into
stud and tighten. (In the center hole pattern.)
Rotate damper and damper support so damper
faces the back vent opening. Center and resecure
with four (4) screws. (See figure 21 .)
CAUTION: Damper flap must swing freely.
I I1=
f iX. DAMPER_ /_ /
°_BOLT _._l _ _X_X l'_I _BOLT_(
_RN BACK SUPPORT SCR:SL.._T o 1_
Figure 21
m
m
.
Attach the rear air duct baffle (See page 4, figure
4) to oven with two (2) plastic rivets. (See figure 22.)
_ PLASTIC
RIVETS
REAR
AIRDUCT
BAFFLE
Figure 22
C.
Inside venting.
Follow instructions included in the recirculating
filter kit. Whirlpool kit number RCH6000, Part
Number 788000. Available at your Whirlpool
Dealer.