Whirlpool MH6300XM0 Installation Instructions Manual page 6

If youdo notknowhowtolocatea wallstud,con-
sult a localbuildingcontractor f or help.
CAUTION: When mounting the microwave oven to
the wall, you must locate and attach the unit to a
minimum of one 2" x 4" wall stud.
,
Drive a small diameter nail through the center of
holes E, F, G & H of the wall template. If a wall
stud is hit with the nail, remove the nail, drill 3/16"
hole into the stud and use 1/4" x 2" lag screws
when attaching wall back support. If you hit drywall
only with the nail, drill 5/8" diameter hole and use
1/4" hollow wall anchor bolts. Insert anchor bolts
through 5/8" drilled hole; grasp both strap ends
firmly. (See figure 9.)
TOGGLE
I o I
Figure 9
Pull toggle firmly against side of wall. (See figure 10.)
WASHER
Figure 10
Snap off plastic straps flush with washer. (See figure
12.)
0
Figure 12
,
o
o
,
,
10.
Drill at least 3/16" diameter hole for lag screw
in hole pattern of wall template into one or more
wall studs. This is a must.
Drill 1/2" holes J & K in upper corners of wall
template. These are clearance holes for the back
of the two rod fasteners.
Drill 1/2" holes A & B through top cabinet template
and cabinet.
Locate and mark power cord clearance hole
through top cabinet template. Drill or cut a 2"
diameter hole.
Install edge guard (in Installation Hardware
Package, see figure 4, page 4) if the top cabinet
is metal. This will prevent cord from rubbing on
cabinet bottom. No edge guard is required for
wood cabinets.
Cut opening for exhaust duct connection (top ex-
haust vent or rear exhaust vent.) If you are using
the Recirculating Filter Kit, DO NOT cut an open-
ing in your cabinet. Refer to the Instructions
located in the Recirculating Kit before proceeding.
11. Remove templates.
Slide washer along straps until inner rim of washer
seats completely inside of drilled hole. (See figure 11 .)
lo
,
PRODUCT SEPARATION
INTO OVEN AND
1 BACK SUPPORT
Remove product from carton following instructions
on carton. Due to some sharp edges, use caution
when moving the appliance.
Determine how high your cabinet is above the
rangetop. Cut carton along dotted line "A" for
6