Installation And Basic Configuration; Hardware Installation; Accessing The Web Configuration Menu; Obtaining The Voip Phone Ip Address - NetComm V90 Quick Start Manual

Installation and Basic
Configuration

Hardware Installation

1. Connect the handset and telephone cord to the base of the VoIP Phone.
2. Use the enclosed Ethernet cable to connect the LAN port to a hub or switch,
or to a DSL Router or Cable Modem.
3. Connect the power supply using the enclosed AC power supply (Note:
external power supply is not required if V90 connects to a PoE enabled
network via it LAN port).
4. For the first time installation, the phone will scan the network for available
services which are DHCP, PPPoE, and Fixed IP. Select the preferred service
and enter the required information if needed. No user input is required for
DHCP service. User ID and Password are required for PPPoE. IP address,
Netmask, and Gateway IP Address are required for Fixed IP mode.

Accessing the Web Configuration Menu

The steps for accessing the V90 Web Configuration Menu are:
Obtain the V90 IP address.
Enter the IP address into a browser.
Log in to the V90 web configuration page.

Obtaining the VoIP Phone IP Address

To retrieve the IP address from the VoIP Phone:
When the phone is in the on-hook state, press Menu.
NetComm Ltd.
2
7