Level Range - Whirlpool WERC4101SB2 Installation Instructions Manual

_iiiiiiiilt Oil_?iiii:;iii::i _jji::ii!_ i_Ii_i!_ ¸ _ ii%_:iii_::iii:_ii !i,i,'ii::tll iiOl_i!
1. Check that all parts are now installed. If there is an extra part,
go back through the steps to see which step was skipped.
2. Check that you have all of your tools,
3. Dispose of/recycle all packaging materials.
4. Check that the range is level. See "Level Range."
5. Use a mild solution of liquid household cleaner and warm
water to remove waxy residue caused by protective shipping
material, Dry thoroughly with a soft cloth. For more
information, read the "Range Care" section of the Use and
Care Guide.
6. Read "Range Use" in the range Use and Care Guide.
Emectdcat Shock Hazard
Electrically ground range,
Failure to do so can resuJt in death, fire, or
electrical shock.
7. Plug into a grounded outlet. Turn power on.
8. Turn on surface burners and oven. See the Use and Care
Guide for specific instruction on range operation.
If range does not operate, check the following:
• Household fuse is intact and tight; or circuit breaker has not
tripped.
• Range is plugged into a grounded outlet.
• Electrical supplyis connected.
• See "Troubleshooting" in the Use and Care Guide,
9. When the range has been on for 5 minutes, check for heat. If
range is cold, turn off the range and contact a qualified
technician.
Tip Over Hazard
A child or adult can tip the range and be killed.
Connect anti-tip bracket to rear range foot.
Reconnect the anti-tip bracket, if the range is moved.
Failure to follow these instructions can resumt in death
or serious burns to children and adumts,
When moving range, slide range onto cardboard or hardboard to
avoid damaging the floor covering.
If removing the range is necessary for cleaning or maintenance:
1. Unplug range or disconnect power.
2. Slide range forward to complete cleaning or maintenance.
3. Check that anti-tip bracket is installed:
• Look for the anti-tip bracket securely attached to floor.
• Slide range back so rear foot is under anti-tip bracket,
4. Check that range is level.
5. Plug in range or reconnect power,