Moving The Range - Whirlpool GS395LEHS7 Installation Instructions Manual

Gas range
Table of Contents

Advertisement

if range does not operate:
[_ Check that the circuit breaker is not tripped
orthe house fuse Mown.
[_ Check that the power suppUycord is pUugged
into the wall receptacle.
[_ Check that gas Uineis turned on.
[_ See Use and CareGuide for trouMeshoofing list.
ff you need assistance:
ff you have questions about operating, cJeaning
or maintaining your range:
[_ Refer to Use and Care Guide.
[_ Call the Consumer Assistance Center. Check
your Use and Care Guide for a toll-free
number to call or call the deaUerfrom whom
you purchased this appUiance.The dealer is
listed in the Yellow Pages of your phone
directory under "Appliances -- Household --
Major -- Service and Repair."
if you need service:
Maintain the quality built into your range by
calling an authorized service company.
To obtain the name and number of an
authorized service company:
[_ Contact the dealer from whom you
purchased your range; or
[_ Look in the Yellow Pages of your telephone
directory under "Appliances -- Household --
Major -- Service and Repair;" or
[_ Call the Consumer Assistance Center.
The toIFfree number is listed in your Use
and Care Guide.
When you call, you will need:
[_ The range model number.
[_ The range serial number.
Both numbers are listed on the model/serial
rating plate located on the frame behind the
storage drawer.
Moving the range:
Tip Over Hazard
A child or adult can tip the range and be
killed.
Connect anti=tip bracket to rear range
foot.
Reconnect
the anti=tip bracket, if the
range is moved.
Failure to fol!ow these instructions can
result in death or serious
burns to
children
and adults.
When moving range, sJide range onto cardboard
or hardboard to prevent damaging the floor
covering.
If removing the range is necessary for cleaning
ormaintenance:
1. Remove the storage drawer.
2. Shut off the gas supply to the range.
3. Slide range forward, away from the wall, just
far enough to disconnect the gas and electric
supply lines.
4. Slide range forward to complete cleaning or
maintenance.
5. Making sure the anti-tip bracket isinstalled:
• Look for the anti-tip bracket securely attached
to floor.
• Slide range back so rear range foot is under
anti-tip bracket.
6. Check that range is level.
7. Reconnect gas line to range and check for
leaks.
8. Plug power supply cord into outlet. Reinstall
storage drawer.
Printed in U.S.A.
Part No. 8273170 Rev. A
Benton Harbor, Michigan 49022
© 2000 Whirlpool Corporation

Advertisement

Table of Contents
loading

Table of Contents