Washing Sequence - Haier HWM130-0523S User Manual

Washing sequence

Wash timer Wash selector
(To set to below 2 minutes, (standard current,
first set to 5 minutes then strong current)
turn it back. it can increase
the service life of the timer).
STRONG
STANDARD
15
3
12
6
WASH SELECTOR WASH SELECTOR
WASH TIMER WASH TIMER
9
Wash
1.Water-filling selector
Set the water inlet selector at the "WASH" side.
(Figure 1)
2. Fill the water and add the dissolved washing
powder to make the water level reach the preset
position. (Figure 2)
Run washing program for some time to stir and
dissolve the powder completely.
3.Put in the laundries. If the water quantity is
insufficient, please add water.
4.Select the current.
Select the strength of the current according to
the laundries. (Figure 3)
5.Select the washing time
Select the washing time according to the laundries.
(Figure 4)
6.After washing, the buzzer will ring. Set the "WASH
SELECTOR" at "DRAIN". (Figure 5).
Buzzer
(The buzzer will ring when
the washing finishes)
OFF
DRAIN DRAIN
MAX
BUZZER BUZZER
8
Water-filling selector
Water-filling entrance
(to set to below 1 minute,
first set to 2 minutes then
turn it back. it can increase
the service life of the timer).
4
WASH SPIN
STRONG
STANDARD
DRAIN
WASH SELECTOR
15
3
12
6
9
WASH TIMER
STRONG
STANDARD
DRAIN
WASH SELECTOR
Spin timer
5
1
2
3
SPIN TIMER SPIN TIMER
Figure 1
Figure 2
Figure 3
Figure 4
Figure 5