Mounting Instructions - Pro-Tech 7030SL Owner's Manual

IMPORTANT!
date. Write replacement date onto "REPLACE by" label affixed to side of alarm.

MOUNTING INSTRUCTIONS:

FOR 7035:
After selecting the proper alarm location
as described in Section 3, drive a screw
into the wall at eye level, leaving the
screw-head about ¼ inches from the
wall.
Hang alarm firmly onto screw-head.
Add the telephone numbers of the local emergency service provider and a qualified
technician to the self-adhesive labels provided.
the other label near a source of fresh air where you plan to gather when the alarm is
activated.
After installation is completed, TEST your alarm by pressing the
least 2 seconds. Detailed testing instructions are outlined in Section 7.
CAUTION!
!
all rooms and areas of the residence.
Alarm should be replaced after 5 years from installation
1/4"
CO detection is best achieved by the installation of CO alarms in
- 6 -
FOR 7030SL/7035SL:
 Remove mounting plate from the box.
If plate preassembled, slide to unlock
position to remove from back of alarm.
 After selecting proper alarm location
as described in Section 3, fasten the
mounting plate to the wall at eye level.
Slide alarm down onto mounting plate,
and secure with a screw through the
flange on top of the alarm.
Place one label next to the alarm, and
TEST/RESET
button for at