Installation Instructions - Pro-Tech 7030SL Owner's Manual

WARNING!
!
4.
NEAR THE COOKING AREA:
appliances. CO may be generated in the cooking process and cause nuisance alarms.
Also, cooking grease can build up on the alarm and cause alarm failure.
CLOSE TO A FURNACE, WATER HEATER, OR SPACE HEATER: These devices
often spill out small amounts of CO when they first turn on.
IN GARAGES: Automobile exhaust contains CO and will activate alarm.
IN DUSTY AREAS: Dust can build up on alarm and prevent it from working properly.
IN CLEANING SUPPLY ROOMS: Chemicals used in household cleaning and painting
supplies can cause nuisance alarms.
IN VERY HOT OR COLD AREAS:
o
which are below 40
IN DEAD AIR SPACE: Do not install alarm within 1' of where wall meets ceiling or floor.
IN HAZARDOUS LOCATIONS: This alarm is not suitable for installation in a hazardous
location, as defined in the National Electrical Code.
NEAR WIRELESS DEVICES:
devices. Radio Frequencies (RF) may interfere with the CO alarm's proper operation.

5. INSTALLATION INSTRUCTIONS

NOTE: Review Section 3,
LOCATIONS TO AVOID
The proper power for the 7030SL and 7035/7035SL CO alarms is a 9V battery. Only
use Ultralife U9VL-J Lithium or Duracell MN1604 Alkaline batteries.
Constant exposures to high or low temperature, or high humidity, may shorten
battery life.
BATTERY INSTALLATION AND REPLACEMENT - 7035:
1. Open the battery door to install original battery or replace old battery, and attach a
new 9V battery to the battery cable. Battery must snap firmly onto both connectors.
2. Press the battery reminder lever down, place the battery on top of the lever and into
the battery compartment, and close the battery door.
3. Press the
TEST/RESET
BATTERY ACTIVATION AND REPLACEMENT - 7030SL/7035SL:
1. Pull the Power Tab completely out of the unit to activate the alarm. Press the
button to verify activation. (See TESTING in Section 7)
TEST/RESET
2. To replace battery, loosen the security screw on the battery door with the ProTech
driver bit (enclosed in box).
3. Open the battery door, remove and disconnect old battery, and attach a new 9V
battery to the battery cable. Battery must snap firmly onto both connectors.
4. Press the battery reminder lever down, then place the battery on top of the lever and
into the battery compartment.
5. Close the battery door, and drive the security screw through the door into the alarm
backplate. (Keep the ProTech driver bit for future use)
6. Press the
TEST/RESET
WARNING!
!
OTHER TYPE OF BATTERY, EXCEPT AS SPECIFIED IN THIS MANUAL.
CAUTION!
!
REMINDER LEVER IN THE BATTERY COMPARTMENT, THE BATTERY DOOR WILL
NOT CLOSE, AND THE ALARM CANNOT BE SECURED TO MOUNTING PLATE.
LOCATIONS TO AVOID
Do not install the alarm within 5 feet of cooking
Do not install unit on any outside wall or in areas
F (4.4°C) or above 100
Do not install the alarm within 1 foot of wireless
RECOMMENDED LOCATIONS OF ALARMS,
, Prior To Installing Your Alarm.
button to verify activation. (See TESTING in Section 7)
button to verify activation. (See TESTING in Section 7)
DO NOT USE RECHARGEABLE BATTERY, OR ANY
IF THE BATTERY DOES NOT HOLD DOWN THE
- 5 -
o
F (37.8°C).
And Section 4,