Advertisement
Available languages
Available languages
Cooktop
Installation
1. All Ceramk-Glass
Cooktops
Visually inspect the cooktop for damage. Also make
sure all cooktop screws are tight (see Figure 8).
SCREWS
Figure 8
Set the cooktop into the countertop cutout.
.
COOKTOP
NYLON
SPACER
RETAINER
BRACKET
Figure 10
COUNTERTOP
_-
Retainer Brackets Must
Be Installed At Least
1/16" (0.16 cm) BELOW
Countertop
Models: 26" and 36" (36" X 18") Coil Elements
Cooktops
Set the cooktop into the countertop
cutout. Lift the
cooktop and fasten the ends of the box to the counter
with wood screws (figure 11 ). Lower the cooktop.
Align the knobs on the shafts and press down with
even pressure.
NOTE: Do not use caulking compound; cooktop
should be removable for service when needed.
Do not remove the nylon spacers on
the edges of the cooktop.
These spacers center the
cooktop
in the space provided.
The cooktop
must
be centered
to prevent
excess heat buildup
that
may result in heat damage
or fire (see Figure 9).
6 NYLON SPACERS
POSITION BRACKETS
,.
ON UNIT CUTOUT
-- "
CENTER LINE
....
"-
..
//"
2 RETAINER _ 4;- ...............
BRACKETS
..........
Figure 9
..... i :!:>
.
CO0 KTOP_r
. wf...,f'_"j COUNTE RTOP
J
c RE W
]_
BURNER BOX
Figure 11
Models: 32" Coil Elements
Cooktops
1. Place cooktop into countertop opening and
center unit in cutout.
2. Remove all surface units and drip bowls.
3. Unit clamp clown information.
Once unit is
installed in counter opening, you must clamp unit
clown as shown in figure 12.
4. Put back all surface units and drip bowls.
5. Make electrical connections as outlined in
"Electrical Connection"
section.
The retainer
brackets MUST be installed,
to meet
local codes or, in their
absence, with the National
Electrical Code ANSI/NFPA No. 70--latest
edition,
or with CSA Standard
C22.1, Canadian
Electrical
Code, Part 1 (see Figure 10).
Advertisement
