Windscreen Washers; Rear Window Wiper And Washers - Ford Kuga Owner's Manual

A
E71013
A Low sensitivity
B On
C High sensitivity
If you switch autowipers on, the wipers will
not cycle until water is detected on the
windscreen. The rain sensor will then
continuously measure the amount of water
on the windscreen and adjust the speed
of the wipers automatically.
Adjust the sensitivity of the rain sensor
using the rotary control. With low
sensitivity, the wipers will operate when
the sensor detects a lot of water on the
windscreen. With high sensitivity, the
wipers will operate if the sensor detects a
small amount of water on the windscreen.

WINDSCREEN WASHERS

E71016
Wipers and Washers
B
While the button at the end of the lever is
pressed the washer will work in
conjunction with the wipers.
C
After releasing the button, the wipers
operate for a short time.
REAR WINDOW WIPER AND
WASHERS
Intermittent wipe
E71017
Pull the lever towards the steering wheel.
Reverse gear wipe
The rear wiper will be activated
automatically when selecting reverse gear
if:
The rear wiper will follow the front wiper
interval (at intermittent or normal speed).
42
WARNING
Do not operate the washer for more
than 10 seconds at a time, and never
when the reservoir is empty.
the rear wiper is not already switched
on,
the wiper lever is in position A, B, C or
D and
the front wiper is operating (when set
to position B).