Upgrade Firmware - Sapido RB-1602 User Manual

2. New Password (Confirm)
Enter the new password again for confirming.
3. Apply & Cancel
Click Apply to continue or Cancel to clear the settings on this page.
Note: 1. Only the password can be changed, the user name for administrator is admin and not to be changed.
2. If you forget administrator's password, please reset 11N WLAN Mobile Server Router to default setting by
pressing the "Reset" button on the rear panel over 5 seconds. And the password will return to admin.
5.5.2

Upgrade Firmware

There is certain risk while upgrading firmware. Upgrading firmware is not recommended
unless the significant faulty is found. You can upgrade the firmware of SAPIDO Light N+
Broadband Router on this page. Make sure the firmware you want to use is on the local hard
drive of the computer. Click Upgrade Firmware to proceed.
1. Update Firmware
Click on Browse... button to search your local hard drive and locate the firmware to be
used for update.
2. Upload & Reset:
Click Upload to upgrade the firmware or Reset to restore to factory default Settings
Note: 1. To prevent the firmware upgrading interrupted by other wireless signals and caused failure. We
recommend using wired connection to do the upgrading.
2. Before upgrading the firmware, please remove any USB device which connected with this router.
The firmware upgrade will not remove your previous settings.
3.
Reset button:
On the back of this router, there is a reset button. If you can not login the administrator page
http://www.sapido.com.tw/
77
User Manual 1.0