Ⅲ、Code
Code
setting
Code setting
setting
1 1 1 . Press**00,XXXX and enter into the coding state.(the original
password of the manager is 2098)
2. 2. 2. Press **02 to change the coding state into "0".
3. 3. 3. Using order code **16
the floors (If it is over 9 floor,please use mixed dialing. Set code "7",you
can dial three and four number mixly). Please press "#" to exit
programming.
The
quick
(Recommendation )
☆ The door station provides a quick order "**41" if the room number
encoding method conforms to the rule of table 1, Just do as
follows:press **00, XXXX (manager password), **41, then it will
come to the programming rule as table one does.
☆ The door station provides a quick order "**42" if the room number
encoding method conforms to the rule of table 2,
to set the number of dialing,it depends on
establishing
www.cusamintercom.com
of
the
extension
7
phone
number:
Need help?
Do you have a question about the Coding Intercom and is the answer not in the manual?