Related Manuals for Haier HWM40-32
Summary of Contents for Haier HWM40-32
- Page 1 Single-tub Washing Machine This manual is for HWM40-32 Please read this manual carefully before using. Retain it for future reference. User's manual...
-
Page 2: Table Of Contents
Contents Names of the parts Safety precautions Installation and adjustment Preparation before washing Put in the laundries Put in the detergent Select the wash time Close the top cover Finish washing Disposal after washing Trouble-shooting Packing list *Specification... -
Page 3: Names Of The Parts
Names of the parts Top lid Filter cap Lint filter(Installed by user) Panel support Pulsator cabinet base Meaning and description of the symbols Contents marked with that symbol are related to the safety of the product and the personal safety of the users. Please operate in strict conformity to the contents. -
Page 4: Safety Precautions
Safety precautions Please insert the power cord into special receptacle with rated vol- tage.Be sure to use single-phase three pins receptacle.The earthing terminal of the receptacle must be earthed reliably.If possible,please adopt electric leakage protector. Earth If the power cord is bad, to avoid risk it is required to replace it by the technicians ofour special shop or the after-sale service department. - Page 5 Safety precautions Do not stretch hands into the working machine. It is dangerous even if the rotation is slow. Take special care of the children. Do not put any hot or heavy items ( such as the kettle with hot water ) on the washing machine.
-
Page 6: Installation And Adjustment
Installation and adjustment Please install and adjust the machine according to the requirement of the manual. It is very important to your security and correct operating the machine. Usage of the drain hose The drainage shall be smooth with the drain hose. 1.The height of the drain hose shall be less than 10cm , or the drainage will not be smooth enough and cause... -
Page 7: Install The Water Inlet Hose ; Select The Water Level
Adjust the installation position The largest permitted slope of the bearing surface of the washing machine is 2. Slanting or uneven ground will cause unstable operation of the machine. Please check with following methods: Hang a becket with weight to confirm if the washing machine is horizontal. Install the water inlet hose ;... -
Page 8: Preparation Before Washing
Preparation before washing Pay attention to followings before washing the laundries Confirm Clear the pocket. there's special Take out the requirement for coins , sand, the laundries. hairpins etc. A. Check if the laundries are applicable for washing with machine. b. -
Page 9: Put In The Laundries
Put in the laundries The capacity of washing of the machine refer to the largest weight of the standard laundries under dry condition that can be washed in one time. Laundries quantity in one washing cycle shall be lower than the rated capacity. -
Page 10: Put In The Detergent
Put in the detergent How to use the whitener Fill water to decided level. Dilute the whitener with container. Pour it slowly into the washing tub. Avoid using whitener on laundries with color or pattern as they are prone to lose color. The whitener shall not touch the laundries directly. -
Page 11: Trouble-Shooting
Disposal after washing Cleaning the lint filter The lint filter must be used during washing. It must be cleaned in time after each using. 1. Take off the lint filter Put hand at the indicated position. Push down to take it off. (See to Figure 1) 2. -
Page 12: Packing List
Packing list Quantity Name One piece User's manual One piece Water inlet hose One piece Lint filter Water-filling jointer One piece Single-tub washing machine One set Specification Water level/Water quantity (about) Maximum/43L Medium/36L Minimum/30L Injection pressure(MPa Rated washing capacity(kg) 4.0 (weight of standard dry cloth)