Important Safety Instructions; Before Starting; Normal Installation Steps - Electrolux CEW30IF6ISB Installation Insrtuctions

iMPORTANT SAFETY
iNSTRUCTiONS
If the information in this manual is not
followed exactly, a fire or electrical shock may result
causing property damage, personal injury or death.
®
®
O
®
ALL RANGES
CAN TiP
INJURY TO PERSONS
COULD RESULT
INSTALL ANTI-TIP
DEVICE PACKED WITH
RANGE
SEE INSTALLATION
INSTRUCTIONS
Important Notes to the Installer
1. Read all instructions contained in these installation
instructions before installing range.
2. Remove all packing material from the oven
compartments before connecting the gas and electrical
supply to the range.
3. Observe all governing codes and ordinances.
4. Be sure to leave these instructions with the consumer.
Important Note to the Consumer
Keep these instructions with your owner's guide for future
reference.
• As when using any appliance generating heat, there are
certain safety precautions you should follow. These are
listed in the Use & Care Manual, read it carefully.
Be sure your range is installed and grounded properly
by a qualified installer or service technician.
Make sure the wall coverings around the range can
withstand the heat generated by the range.
To eliminate the need to reach over the surface
elements, cabinet storage space above the elements
should be avoided.
Before Starting
Tools You May Need
For leveling legs and Anti=Tip Bracket:
• Adjustable wrench or channel lock pliers ......... :_ "
• 5/16" Nutdriveror Flat Head Screwdriver __
Electric Drill & 1/8" Diameter Drill Bit (Masonry Drill Bit if
installing in concrete)
For electrical supply connection:
• 1/4" & 3/8" Socket driver or Nutdriver
Additional Materials You May Need
Copper Electrical Wiring & Metal Conduit (for hard
wiring)
Normal installation Steps
1. Anti-Tip Bracket Installation Instructions
Important Safety Warning
To reduce the risk of tipping of the range, the range should
be secured to the floor by properly installed anti-tip bracket
and screws packed with the range. Failure to install the
anti-tip bracket will allow the range to tip over if excessive
weight is placed on an open door or if a child climbs upon
it. Serious injury might result from spilled hot liquids or from
the range itself.
If range is ever moved to a different location, the anti-tip
brackets must also be moved and installed with the range.
Instructions are provided for installation in wood or cement
fastened to either the floor or wall. When installed to the
wall, make sure that screws completely penetrate dry wall
and are secured in wood or metal. When fastening to the
floor or wall, be sure that screws do not penetrate electrical
wiring or plumbing.
A,
Locate the Bracket Using the Template - (Bracket
may be located on either the left or right side of the
range. Use the information below to locate the bracket
if template is not available). Mark the floor or wall
where left or right side of the range will be located. If
rear of range is against the wall or no further than 1-1/4"
from wall when installed, you may use the wall or floor
mount method. If molding is installed and does not
allow the bracket to fit flush against the wall, remove
molding or mount bracket to the floor. For wall mount,
locate the bracket by placing the back edge of the
template against the rear wall and the side edge of
template on the mark made referencing the side of the
range. Place bracket on top of template and mark
location of the screw holes in wall. If rear of range is
further than 1-1/4" from the wall when installed, attach
bracket to the floor. For floor mount, locate the bracket
by placing back edge of the template where the rear of
the range will be located. Mark the location of the
screw holes, shown in template.
B. Drill Pilot Holes and Fasten Bracket