Electrolux EW30DF65GWA Quick Reference

×
OPERATING
S_NGLE BURNERS
1. Push the desired gas surface control
knob in and turn counterclockwise
out of the OFF position -Fig.1.
2. Release knob and rotate to
(lite)
r
position. Visually check that the
needed burner has lit.
3. To adjust, push the knob in and turn
counterclockwise to a flame size
setting that best fits your need.
Fig.1
GAS BURNER LOCATIONS
............ ,
.... i
" 2i ..........
OPERATING M_No2-MAX _'M
BURNER
1. Push the right front surface control
knob in and turn counterclockwise
out of the OFF position -Fig. 1.
2. Releasethe knob and rotate to the
(lite) position.
Note: Although all electronic surface
ignitors will spark at the same time,
only the selected surface burner will
lite.
3. Visually check that both the inner and
outer rings have lit -Fig. 4.
When both burners are lit, continue to
turn the control knob counterclockwise
to adjust to the desired flame size.
4. If only the inner burner is needed,
continue to rotate the gas control
knob counterclockwise past grey
area as shown in Fig. 2.
5. Adjust the inner flame to desired size
-Fig. 3.
Fig. 2
@
@
@
@
Standard burner -9,500 BTU-best
for most surface cooking require-
ments.
Large burner -14,000 BTU- best for
bringing large quantities of liquid to
boil or when preparing large
quantities of food.
Min-2-Max
TM
burner -18,000 BTU-
Capabilities of large burner
combined with a simmer burner.
TM Perfect Simmer -5,000 BTU-
best for simmering delicate sauces,
melting chocolates, etc.
Fig. 4
Fig. 3
LUXUR%GUDE TMOVEN RACKS
REMOVING GUDE RACKS
Use thumbs to press in on both left
and right spring-loaded release levers -
Fig. 1-. Place the remainder of both
hands over the upper front of the glide
rack. While pressing in on both levers,
pull the rack straight out slightly and
release thumb levers. Using both
hands grasp both the upper and lower
portions of the glide rack (-Fig. 1); pull
rack using both hands straight out
until reaching the stop position -Fig 2-.
At the stop, lift up front of rack slightly
and continue to pull rack away from
oven -Fig 3-. Be sure to hold on both
upper and lower rack portions when
removing from or handling rack outside
of the oven - these rack portions move
independently and are difficult to
handle unless held together
REP_C_NG GL_DE RACKS
Grasp both upper and lower portions
of glide rack, lift and place the rack
resting evenly between the oven cavity
walls. Tilt the front of the rack upward
slightly and slide the rack completely
into position. Some force may be
necessary to make sure the oven rack
has snapped completely back into
place.
)per rack
portion
lower rack
portion
Fig. 1
Fig. 2
Fig. 3
Quick Reference
30" Free-Standh_g Dual Fuel Range
Thank you for choosing Electrolux, the new premium brand in home appliances. We have
provided you with this guide so that you may begin using your appliance right away.
SETTING CLOCK AT POWER UP
You will be prompted to enter the time of day in the event of a power failure or when you
first provide power to your appliance.
• When your appliance is first powered up, 12:00 will
flash in the display.
Enter the time of day using the numeric key pads and
press START to set.
If an invalid time of day is entered, the control will triple
beep. Re-enter a valid time of day and press START. If
CANCEL is pressed your clock will start with a time of
12:00.
WAVE TOUCH TM D_SPLAY MODES
SLEEP MODE
Your Wave Touch
TM
control will remain in a sleep mode when not in use. Only the clock
will display during this mode. You will need to wake the control to begin an oven feature.
The cooktop is available in sleep or awake mode.
!
P
AWAKE MODE
To wake the control touch within the display panel in the general area shown. After 2
minutes without activity, go back into sleep mode. To start cooking you must select
either the upper oven or lower oven. User preferences will be available during this mode
as well as timers, oven light and the control lock.
316506704