How To Unlock With Enrolled Fingerprint; How To Delete Enrolled Fingerprints - Q-See QSB180 User Manual

LOCK
Input the rest 10 The green indicator
digits of fingerprint flashes
enrollment code
Step 3: Repeat above two steps for more enrollments.
NOTE: To enroll the same finger twice (two templates for one
fingerprint) is recommended.

How to unlock with enrolled fingerprint?

2.6
Step 1: Input 0,1,2,3 continuously, a long beep will be heard, green
indicator flash once, red sensor indicator flashes. (figure 2-17)
Step 2: Put an enrolled finger onto the sensor immediately while the
red sensor indicator is flashing. Motor driving will be heard. During
any steps of authentication, if the red indicator flashes after moving
away the finger, a second authentication will be needed. Repeat the
above steps. (figure 2-18)
The green indicator
Put your finger
flashes,follows 2
onto the sensor
beeps
Input wake-up code,e.g.0,1,2,3
green indicator
flash once
Put an enrolled finger onto
the sensor
Step 3: Move away the finger and rotate the handle to unlock the door,
5 seconds later the door will be locked again automatically.(figure 2-19)
2.7

How to delete enrolled fingerprints?

Step 1: Press and hold digit 3
short beep, as shown in 2-20.
Step 2: Input fingerprint enrollment code continuously (the default
fingerprint enrollment code is 2,1,3,2,1,3,2,1,3,2,1, if you have
changed it, then input the new one), a beep will be heard, a second
beep will follow in 5 seconds, the green indicator flashes, which shows
the successful operation. (Figure 2-21)
for about 6 seconds till you hear a
Press and hold digit 3
for about 6 seconds