Table of Contents
Advertisement
LOCK
Closing with a mechanical key
Rotate the mechanical key in the keyhole ( 90
handed lock, 90 clockwise if left handed lock) till the mechanical key
is vertical, draw out the mechanical key. The door is locked.(figure 2-4)
Left Handed
Wake-up code
2.2
What is wake-up code?
Normally, the fingerprint sensor
inputting correct code. Before unlocking the door with fingerprint, one
should input valid code to
authenticate the enrolled fingerprints. The default wake-up code is
0,1,2,3
How to change the wake-up code?
Step 1 : Press digit
beep.(figure2-5)
anticlockwise if right
Right Handed
sleeps
till it is
waken up
wake up
the sensor so that it can
3
and hold it for 6 seconds till you hear a
Press digit 3 and hold
it for 6 seconds
by
Step 2 : input the previous Wake-up code continuously (the default
code is 0,1,2,3), a long beep is heard and green indicator flash once.
(figure 2-6)
input the previous Wake-up code
the default code is 0,1,2,3
green indicator
flash once
Step 3 : Immediately input twice the new Wake-up code continuously.
If the new code is twice input correctly, a long beep will be heard and
green indicator flashes indicating the success of the operation.
(figure 2-7)
input twice the new Wake-up code
green indicator
flashes
The principle for key combination of wake-up code
The initial digit of Wake-up code must be 0 . For example, you can
choose(0,0,0,0) , or (0,2,2,2) etc. But do remember the wake-up code
begins with 0 .
How to restore the default wake-up code?
(0,1,2,3) is the default wake-up code for this lock, if you forgot the
new wake-up code you've modified, you can restore the default wake-
up code by following below steps:
Advertisement
Table of Contents
