Unlock With Group Member Fingerprint; Unlock With Mechanical Key; How To Set The Status Of The Lock; Lock Status - Q-See QSE7F4 User Manual

QSE7F4 USER MANUAL
be locked, Master fingerprint or group member fingerprint can cancel the
locked status, or the locked status will be deleted in 1 minute automatically.
2.Blue background and green indicator light up, a long beep is heard, the inside
motor is activated.
3.Rotate the outside lever to unlock. (Figure2-9)

2.7.2 Unlock with group member fingerprint

1.Place an enrolled group member finger on the sensor, the lock is activated
after the infrared detector detected the finger. The blue background lights,
green indicator light and the red light in the sensor flashes; or press "0", the
blue background, green indicator light and the red light in the sensor flashes,
place an enrolled group member finger on the sensor.
NOTE: If invalid finger was used 10 times continuously, the sensor will be
locked, Master fingerprint or group member fingerprint can cancel the locked
status, or the locked status will be deleted in 1 minute automatically.
2.Green indicator flashes once and lights up, a long beep is heard and the inside
motor is activated.
3.Rotate the outside lever to unlock. (Figure2-9)
NOTE: within 5 seconds after the inside motor is activated, the outside lever
must be rotated to unlock. Otherwise, the door will be locked again
automatically.
16
2-9
QSE7F4 USER MANUAL

2.7.3 Unlock with mechanical key

1.The same operation with step 1 in 2.5.1.
2.Insert mechanical key into the keyhole, turn the key (anticlockwise if right
handed lock, clockwise if left handed lock) until it unlocks. (Figure2-10)
3.Push the door to open.

2.8 How to set the status of the lock?

In 2.2, we've introduced Lock status, Lock-out status and "Normally open"
status, detailed explanation follows:

2.8.1 Lock status

If the lock is not in "Lock-out status" or "Normally open status" it means that
the lock is in lock status. In this case, if you are outside the room, you can
open with either of Emergency PIN, Group member fingerprint or mechanical
key; if you are inside, just rotate the inside lever to open the door.

2.8.2 Lock-out status

Rotate the outside/ inside lever to reach out the deadbolt, and make the lock in
Lock-out status. (Figure2-11). In this case, the red indicator flashes once a
second. If you are outside the room, you can open with either of Emergency
PIN, Group member fingerprint or mechanical key; if you are inside, just rotate
the inside lever to open the door.
2-10
17