Table of Contents
Advertisement
LOCK
CAUTION: All the fingerprints enrolled will be deleted.
Passage mode
2.8
8
What is passage mode ?
The lock is in open status all the time. One can rotate the handle and
unlock the door at any time. This operation is suitable for office or
meeting room.
8
How to set the door into passage mode?
Step 1: Unlock the door with unlocking code or enrolled fingerprint first
refer to 2.3.5 or 2.6;
Step 2: Within 5 seconds after unlocking the door with either
fingerprint or unlocking code, press the digit 0 and hold it for 2
seconds, a long beep is heard and release the press. The lock has
been set into passage mode . You can open the door by rotating the
handle any time till you cancel the setting. (figure 2-22)
Input fingerprint enrollment
code continuously (the default
fingerprint enrollment code is
2,1,3,2,1,3,2,1,3,2,1
Press the digit 0 and
hold it for 2 seconds
8
How to cancel passage mode ?
There are two options:
A.Input the valid Wake-up Code and the lock come back to close
state. Or,
B.Input the valid unlocking code and the lock come back to close
state.
How to initialize the lock?
2.9
Step 1: Open the battery cover .
Step 2: Take out 1 of the batteries, then replace the battery again after
3 seconds. Press and hold the digits 0 , 1 , 2 , 3
same time while replacing the battery. Release the digits after the red
and green indicator flashes and a long beep and a short beep are
heard.
CAUTION: The operation will delete all enrolled fingerprints, Please
make sure you wanna do that.
3.Installation
3.1
Door requirement
Wooden door with thickness from 30-
60mm;
If the door surface is decorated, the
distance from the decorative edge to
the door frame must be above 110mm.
at the
110mm
30~60mm
Advertisement
Table of Contents
