Figure 4-5. Browser-Based Setup Wizard, Third Screen - NETGEAR DG814 Reference Manual

Reference Manual for the Model DG814 DSL Modem Internet Gateway
Your ISP will indicate whether your Multiplexing Method is VC-BASED or LLC-BASED and
which VPI and VCI is used. Enter the information in this screen. The most common
Multiplexing Method is LLC-based. If your service provider does not indicate which one is
used, use LLC-BASED.
Click Next to go to the second ISP Parameters screen, shown in
9.
Figure 4-5. Browser-based Setup Wizard, third screen
This screen determines whether a login program will be run.
• If your service provider does not require a login program, leave Encapsulation as Ethernet.
It is not necessary to enter a Service Type, User Name, or Password. Proceed to Step 3.
• If your service provider uses PPP over Ethernet (PPPoE), select Encapsulation as PPP
over Ethernet, and enter these additional parameters:
If your connection supports multiple ISPs, enter the Service Name of the one you use.
1.
Otherwise leave Service Name blank.
Enter the PPPoE login user name and password provided by your ISP. These fields are
2.
case sensitive.
If you wish to change the login timeout, enter a new value in minutes.
3.
Proceed to Step 3.
• If your service provider uses PPP over ATM (PPPoA), select Encapsulation as PPP over
ATM, and enter these additional parameters:
Enter the PPPoA login user name and password provided by your ISP. These fields are
1.
case sensitive.
4-4
Figure 4-5 below:
Basic Configuration of the Router