NETGEAR DG814 Reference Manual page 66

Reference Manual for the Model DG814 DSL Modem Internet Gateway
The System Status screen shows the parameters listed in
Table 6-1. System Status fields
Field
System Name
Router Firmware Version
WAN Port
IP Address
IP Subnet Mask
DHCP
LAN Port
IP Address
IP Subnet Mask
DHCP
ADSL Firmware Version
Modem Status
Connect Mode
Down Stream
Up Stream
VPI
VCI
6-2
Description
This field displays the Host Name assigned to the router.
This field displays the router firmware version.
These parameters apply to the Internet (WAN) port of the router.
This field displays the IP address being used by the Internet (WAN) port
of the router. If no address is shown, the router cannot connect to the
Internet.
This field displays the IP Subnet Mask being used by the Internet (WAN)
port of the router.
If set to None, the router is configured to use a fixed IP address on the
WAN or to use PPPoE or PPPoA.
If set to Client, the router is configured to obtain an IP address
dynamically from the ISP.
These parameters apply to the Local (LAN) port of the router.
This field displays the IP address being used by the Local (LAN) port of
the router. The default is 192.168.0.1
This field displays the IP Subnet Mask being used by the Local (LAN)
port of the router. The default is 255.255.255.0
If set to None, the router will not assign IP addresses to local PCs on the
LAN.
If set to Server, the router is configured to assign IP addresses to local
PCs on the LAN.
This field displays the ADSL chipset firmware version.
This field displays the state of the ADSL connection to your service
provider, either "Connecting" or "Connected"
This field displays the protocol used to connect to your service provider.
When the ADSL link comes up, the connection will be either "Fast" or
"Interleaved", depending on the way the telephone company has
configured its equipment
This field displays the connection rate in from the service provider to the
router in bits per second
This field displays the connection rate in from the router to the service
provider in bits per second
This field displays the VPI entered in the WIZARD SETUP
This field displays the VCI entered in the WIZARD SETUP
Table 6-1
Maintenance