Connecting The Transmitter; Associating Transmitters & Receivers - Accurate Technology IPcam-SD User Manual

Connecting the Transmitter

The ProRF SPC Transmitter is designed to operate with any ProScale Digital
Readout (DRO) that has a built in SPC data port.
The following illustration uses the
To install the SPC Transmitter:
1. Peel off the backing of the pressure sensitive double faced tape located
on the side of the Transmitter housing.
2. Plug the 10 pin header from the SPC Transmitter into the DRO's SPC
data port. Be sure that all of the pins are properly aligned.
3. Press the Transmitter enclosure securely against the DRO housing to
ensure that the double faced tape contacts both units adequately.
Associating Transmitters & Receivers
Each ProRF SPC Transmitter is assigned a unique 64-bit ID that identifies that
Transmitter to a Receiver. For proper communication to occur between the
Transmitter and Receiver, each Transmitter in the system must be associated
or "learned" by the Receiver.
The association process is a one time operation where the Receiver is placed
into a special mode which listens for new Transmitters to be acquired. To learn
a particular Transmitter, the user then activates a "learn" pushbutton on the
desired Transmitter. The Transmitter sends its unique 64-bit ID which the
ProRF SPC Transmitter User Manual
General Purpose readout as an example.
Page 8 of 12