Set-Up; Setting The Rf Channel - Accurate Technology IPcam-SD User Manual

S 2
ECTION

Setting the RF Channel

The ProRF SPC Transmitter can be configured to operate on 1 of 16 possible
radio frequency channels. The default channel is 0.
Unless there are other ProRF systems in range that could cause a
conflict, the default channel setting of 0 should be used.
Note: If the Transmitter's RF channel is changed from its default setting,
the Receiver's RF channel must also be changed.
To change the RF channel, complete the following steps. If the default channel
is to be used, skip to
1. Use a Phillips screwdriver to remove the two screws from the back of
the housing.
2. Touch a grounded metal surface to discharge any static electricity from
your body, and then remove the front and back cover of the Transmitter
enclosure.
3. Slide out the coin cell battery from the battery holder and set it aside.
4. Locate the address switch in the lower left hand corner of the circuit
board. Set the desired channel using the dip switch. See
Switch Setting
RF Channel Switch
ProRF SPC Transmitter User Manual
Connecting the
Table for switch setting versus RF channel number.
Transmitter..
S -U
ET P
RF Channel
Page 6 of 12